Please, I need help with the block programming done in Control I/O of the palletizer.
@Cesar_Sanchez24
3 жыл бұрын
good video
@ntombomusimubianda2916
4 жыл бұрын
well done
@pengyuanxia6607
4 жыл бұрын
could you plz tell me how to sort small boxes from medium boxes?cuz they have a same height
@thanyaratjanmarn1784
2 жыл бұрын
Hello, I'm from Thailand. Can you do a sorting by height advanced for me to look at, please?🥺
@luis-oy9bq
3 жыл бұрын
hola, no me permite guardar ni abrir proyectos en control i/o, pero si en el factory i/o. ¿A que se deberá?
@anuradhaedachali
3 жыл бұрын
why did you use low sensor and not pallet sensor for latching?
@williamschwab9216
3 жыл бұрын
The Pallet sensor only gives information that a box is coming. There is no information on the size of the box, when then front edge of the box passes thru the sensors there always is a low sensor which is used to latch the box size. If only low sensor (no high sensor) then it is a small box. If both low and high sensor then it is a large box.
@anuradhaedachali
3 жыл бұрын
@@williamschwab9216 ok isn’t it true that if the pallet sensor goes off the true sensor will always go off because they are at the same level.
@anuradhaedachali
3 жыл бұрын
how are you getting the tags displayed when you move cursor in studio?
@williamschwab9216
3 жыл бұрын
When a memory is added you must click on to highlight the memory, then an address box pops up on the bottom of the screen. Here is where you can add a tag, the address is automatically added.
Пікірлер: 14