My 1986 364D international works the same way. It has a 12V sys but still runs a generator. I was trying to figure out how to change the belts but couldn't find any information on it until I found this video. Thanks a lot for the help. Now all I need is for someone to do it for me. LOL. I can see that I am going to leave a lot of skin on all the sharp corners in there. Once again, thanks.
@flyboyslc1
Жыл бұрын
Ole, happy to hear that the vid helped you!
@fitzpreacherfarm6826
2 жыл бұрын
Thank you sir, you have saved me a few headaches.
@flyboyslc1
2 жыл бұрын
Most welcome. Hope your project goes well
@fitzpreacherfarm6826
2 жыл бұрын
@@flyboyslc1 well, my set screw was stuck like yours was. The top was rounded off. I wondered why this tractor did not have an alternator belt when I bought it, now I know. Your video saved me lots of time
@redgreentractorthings9043
2 жыл бұрын
@@fitzpreacherfarm6826 nice feedback. Glad it helped.
@farmallchris
2 жыл бұрын
Well you got it man that’s all that matters and should be good for along time I wonder if putting that grey anti-seize on the threads would help for next time
@flyboyslc1
2 жыл бұрын
Yea Chris, it sure would be a good idea I think on the anti seize. I hit it good with oil. Those belts will outlast this 70 yr old man anyway. That tractor has been under a roof when not working it’s entire life. I can only imagine how difficult it had been if it was all rusted up.
@tadcahow3274
2 жыл бұрын
Do you know part numbers for both those belts...I need to replace mine also, and hope they outlive me
@redgreentractorthings9043
2 жыл бұрын
Tad, I just went to an IH/Case dealer and told them I needed both belts for a Farmall 300. They didn’t cost me that much and I knew I had the right belts both in profile and length. For as rotten a job as it is, I wanted to know that I had the right thing that would last a long time. I was able to find radiator hose sets on eBay.
@boblajoiesr591
2 жыл бұрын
I don't have a grease fitting on my new pump.
@flyboyslc1
2 жыл бұрын
Bob, is that new pump an IH factory part or an aftermarket part?
@boblajoiesr591
2 жыл бұрын
@@flyboyslc1 I don't know.I got it from Steiner tractor parts
@redgreentractorthings9043
2 жыл бұрын
@@boblajoiesr591 Bob, I am pretty sure Steiner isn’t selling IH parts. Don’t know if the last of a grease fitting will make any difference or not
Пікірлер: 14