Sounds a lot better and you're right about running nit and getting it hot. It'll limber up then. BLESSINGS 2 U!
@DrRust
2 жыл бұрын
You too it already is running better I mowed a bunch with it
@lewiemcneely9143
2 жыл бұрын
@@DrRust Can NOT beat the old rigs.
@DrRust
2 жыл бұрын
You’ve got that right
@lewiemcneely9143
2 жыл бұрын
@@DrRust I've seen and dealt with the old and watched the new die outright. No comparison.
@DrRust
2 жыл бұрын
We have a jd compact tractor that’s 25 years old and it’s in pretty rough shape then I see international Titans and jd Waterloo boys that are a century old and wonder where we will be in 50 years
@Ironringbound
2 жыл бұрын
One of the nice features of an updraft is it takes a ridiculous amount of fuel to flood your engine.
@DrRust
2 жыл бұрын
Yes but if you do good luck getting it cleared out
@ThefarmLife.
8 ай бұрын
@@DrRustcould you help me ,my updraft carburetor is pouring gas out of the air intake side
@DrRust
8 ай бұрын
Your float is probably sticking try taking the carburetor apart and clean it up
@ThefarmLife.
8 ай бұрын
@@DrRust it wasn’t doing that before I took it off..I took it apart & cleaned it for the first time and when I put it back together that’s when it started
@DrRust
8 ай бұрын
Take it back apart and make sure the float moves freely and doesn’t touch the side of the carburetor causing it to stick then check the needle and make sure it moves freely Then make sure that when the float is parallel to the upper body of the carburetor when the needle is closed
@wattsup8407
28 күн бұрын
I would assume this applies to all updraft carburetors? I have a 1980 Lo Boy running rich and adjusting doesn’t help.
@wattsup8407
28 күн бұрын
Had a waited a few minutes I’d have heard that I’m doing it wrong. 🤣
@DrRust
28 күн бұрын
@@wattsup8407good luck Try lowering the float
@AndrewHCann
2 жыл бұрын
Got going right also when low idle lupping don't hear got right and when got high idle sounds cold throat got right on money and cap with distributor adjustment should be 3:30 clock on min hand be like on watch or clock ! And want running low idle and mixture screws on just went sound mellow no hard hit missing sounds for low and high! idles !
@darcygulka5627
Жыл бұрын
I replaced the points and condenser on my W6. It doesn’t start now. I backfired when I tried to start it. Any suggestions?
@DrRust
Жыл бұрын
Did you take off the plug wires if not then I would make sure the points are set properly and open and close normally
Пікірлер: 19