Great video series Sir 👍😊 Can't wait to see it in live action 👌 Cheers !!!
@TractorTech
3 жыл бұрын
I couldn't wait to run it.
@RCAFpolarexpress
3 жыл бұрын
@@TractorTech 😊👍
@muzzymuzz9351
3 жыл бұрын
Very nice step by step video,
@TractorTech
3 жыл бұрын
Thanks!
@danonly7
2 ай бұрын
Where was the throttle rod in the package?? I can't find it and it is driving me crazy.
@pnwexplorer5343
2 жыл бұрын
Is the 460 a similar build? Have had a lot laying around never put together
@TractorTech
2 жыл бұрын
It should be pretty close. Really in general the Stihls are pretty similar, the 361 is a little different but it is a new generation saw.
@nathanwesson8423
2 жыл бұрын
My Stihl blew up so I ordered on online and use the old carb does it take a while before it idle
@TractorTech
2 жыл бұрын
Did you try adjusting the carb?
@helmighomestead2976
3 жыл бұрын
great video brother! What did you think of the stock tiny farmertec plug wire they give you?!?! heck, yours looks bigger than mine (famous man words) LMAO mine was like it was for a 9 volt batter kids toy! LOL Dang I didnt get a prefilter either. You got the hookup brother! Been thinking about picking up some of those CNC cut skeleton buck spikes for mine, you seen those things? super agressive and mean looking, would hook into a log like gangbusters I bet!
@TractorTech
3 жыл бұрын
A stihl plug wire is 4.5 or 5.5mm. This one may be slightly under size. I question how good the ignition setup is on these saws. Don't get aluminum spikes. They wear instantly. The OEM style spikes work fine for me. Bigger spikes reduce bar length.
@andrewschris7
3 жыл бұрын
You didn't show how you put impulse line on.
@TractorTech
3 жыл бұрын
I think I used a small pair of needle nose pliers.
@degaw8733
2 жыл бұрын
If like magic the handle goes onto the case. All this work to make these videos and you skipped the hardest part: the intake boot and impulse line. I built a few of these now and figured out it’s much easier to attach those parts to the cylinder and case first then pull them through the outside as the two subassemblies mate together.
@TractorTech
Жыл бұрын
It is hard to film every little thing since I am the camera man and the one doing the work. I don't have enough hands.
Пікірлер: 18