Lots of great additions and all make sense, thanks for sharing!
@mikel2468
Жыл бұрын
Where is the non skid sink cover from?
@mvemerson
Жыл бұрын
Hi Mike. We have replaced this cover with one that is a little bit smaller and fits our sink a lot better. Same thing otherwise: www.amazon.com/dp/B07H9DR43R?ref=ppx_yo2ov_dt_b_product_details&th=1. We found it important to have a 100% silicone cover of the entire thing, after trying one that had stainless bars.
@jayslupesky
10 ай бұрын
Hi, are you still happy with the SCAD TM1 as a waste tank monitor? It sounds like a big improvement over the green/yellow/red system on the Tecma. Did you install this yourself?
@mvemerson
10 ай бұрын
Hi there. Yes and Yes. We are very happy with it and I installed myself. You need access to a side of the tank and in our boat, we were able to get to two of them.
@jayslupesky
8 ай бұрын
Is the rudder feedback sensor the Garmin GRF 10? Thank you!
@mvemerson
8 ай бұрын
Yes, it is. I am still loving it. 😀
@jayslupesky
10 ай бұрын
Do you have a link to the polishing pads? We bought some at Fred Meyer but they are too small to fit snugly like yours seem to. Thanks!
@mvemerson
10 ай бұрын
Interesting. Any 6” pads should do. Here is what we have: IPELY 6 Pcs 6 Inch Wool Polishing Buffing Pad Polishing Buffing Wheel for Drill Buffer Attachment with M14 Drill Adapter a.co/d/g5tsWCj
Пікірлер: 12