Good information . I’ve. Been trying to reload Federals with clay buster wads and getting horrible Crimps!
@chase3760
Жыл бұрын
One thing to look for is that Federal has various shell lengths. Federal is one of my favorites'.
@smsgtbulldog
2 жыл бұрын
Well said
@chase3760
2 жыл бұрын
thanks
@brucehanson4147
Жыл бұрын
Rim of the brass to base of crimp is irrelevant as different feds have different base wads and thus different internal volumes. There are a couple different domestic plastic base wads along with fiber base wads and about half the feds i pick up are actually rio. Just look at the base wad and separate them that way. I use a lot of the cheddite primer but it's not as hot as a fed and one should note you will have to use different load data with it.
@robertfrapples2472
Жыл бұрын
Thank you for saving me the trouble of posting this. He struggles. I was cracking up when he measured to the crimp.
@robertfrapples2472
Жыл бұрын
Federal wads are straight walled. Remington hulls are tapered. Basic.
@chase3760
Жыл бұрын
Basic it is not!! There is nothing basic, each shell has it's own peculiarities. I have found differences in same brand and production runs. Thanks for the input.
@mikenostra5276
2 жыл бұрын
what recipe are you using for the Pink Federal Top Gun Hulls?
@chase3760
2 жыл бұрын
1 1/8 8 shot, red dot powder 18.2 g, wad Claybuster cb2118-12, primer cheddite. I have used this with 15K shells a year.
@ivanwesley8182
Жыл бұрын
@@chase3760 I’ve heard bad things about cheddite primers but never tried them. That’s about the only primer I can find now so I’ve been considering them, this gives me hope that they are ok
@chase3760
Жыл бұрын
@@ivanwesley8182 I have never had a problem with Cheddite primers, and i have used them for years.
@larryjistel3018
Жыл бұрын
Field & Target... not Field & Steam...
@williamcrawford7982
2 жыл бұрын
Trim ?🤫
@chase3760
2 жыл бұрын
Sorry i did not see this. I do not need to trim the hulls.
Пікірлер: 17