Did you have the same code thats on your ecu and did you just do a straight swap job done ? Or was there more to it
@JoniK1
3 жыл бұрын
Self coding virgin ecu from Ebay rover.ebay.com/rover/1/711-53200-19255-0/1?mpre=https%3A%2F%2Fwww.ebay.com%2Fitm%2FFiat-Punto-1-2-ECU-IAW59F-M3-HW303-Plug-Play-Virgin-unit-Self-coding%2F283549056948&campid=5338643528&toolid=10001&customid=jonik
@OritanoVero
3 жыл бұрын
How to recode a virgin ecu (self coding ecu)? Do you know procedure?
@JoniK1
3 жыл бұрын
You need expensive equipment for that so not really a diy job
@OritanoVero
3 жыл бұрын
@@JoniK1 no no there's a misunderstanding.... I already bought a self recoding ecu. Now i have to install it. I was asking you if you know how to do this operation, in order to recode correctly the ecu with key original code. After installing new ecu I have to turn on the ignition and wait? Or I have to turn on the engine and wait for auto-recoding from the key? Thanks.
@JoniK1
3 жыл бұрын
It's done automatically when you first time turn on the power, no need to do anything
@AdydeAdy21
Жыл бұрын
Thank you for this video
@charlesdrake1168
2 жыл бұрын
volessi cambiare la centralina deve essere uguale alla mia? inoltre dopo averla sostituita bisogna fare l'autoapprendimento?
@JoniK1
2 жыл бұрын
It should be same if you have mk2 1.2 8V. No need to do anything else, just plug and play
@hassansharlf9277
2 жыл бұрын
Hi can you please help my fiat punto 1.2 was having ecu problems took fiat dealer which they found p0351 and p0201 and they said the problem is the ecu the gave price which is more than what I paid the car. I looked internet found company who does ecu gave them ecu parts number then I bought ecu from them when I was changing I didn't disconnect the battery as I can't see your video how to do it but I changed the ecu . Car worked perfectly engine light was off but after one hour everything came back engine light car shaking vibration loss of power when accelerate could you please help me I am thinking disconnecting the battery over night. I changed the coil ht leads spark plugs everything
@OrdinaryHandsome
4 жыл бұрын
I've been changing head gasket. After assembly, both coils are keep going off/dead after 10 minutes of driving. ECU cables have been disconnected during head gasket repair process. Any clues?
@JoniK1
4 жыл бұрын
Have you changed new spark plugs and ignition leads?
@OrdinaryHandsome
4 жыл бұрын
@@JoniK1 at the end coils were fine it was ecu.. kept coils off due to a too much oil in the engine. :s
@rodolfolafresa9998
7 жыл бұрын
Jonik what about P0170 ERROR? I changed fuel pump the I checked injectors but they work good. The engine work bad mainly at cold before reaching temperature It seems like a wrong carburetion. The engine doesnt react promptly by pressing accelerator pedal. Throttle body is clean and I changed it one year ago. What do you suggest? Can be ECU problem?? My car is both petrol and methan (aftermarket).
@JoniK1
7 жыл бұрын
Sounds like throttle body problem. First I would try new spark plugs and leads.
@zeljkomikulicic4378
5 жыл бұрын
Sorry on main bad english. I have problem with ecu on my punto 1.2 8v 2001. If i bought ecu on ebay like you, do i need electrican or i can change myself. I ask a car electrician and he ask 200 euro to fiks the problem. Thanks on answer
@JoniK1
5 жыл бұрын
No need, very easy to change the ecu by yourself 😊
@Hdbggjjsjnnsnvf
6 жыл бұрын
My car goes 2 cilinder, i hve changed the ignition coil, the cable, and sparkplug, but still persist, do i have to change the ecu?
@JoniK1
6 жыл бұрын
Yes, there's cheap self coding ecus on ebay. About 80€ with shipping 😊
@darekdarek4920
4 жыл бұрын
Yes pliss check my profile youtube
@joaopnascimento
4 жыл бұрын
Hi. Maybe you can point me in the right direction. My 2002 Punto 1.2 8v, is stopping intermittently. Can be 2 days not doing it. But eventually will happen. When it does, it crancks but doesn't start. Some times the key light stay's on, but not allways. And I don't ear the fuel pump when I turn the key. To escape from this situation I disconnect the battery negative, and connect again. I've checked all the grounds, except removing the ECU to check how it grounds to the engine. Last time it happened I've disconnected the chassis ground (cable that goes from the battery to the chassis and gearbox). I've left the battery and the gearbox side of the cable connected. Disconnected only the chassis ground. Cleaned it and connected again. This did nothing to solve the problem. Which means that, when I disconnect the battery negative, it's the disconnecting of the gearbox (and engine) ground that solves. Also the ECU is grounded in the engine. My diagnostic is: The ECU "crashes" and by disconnecting the negative it resets. Much like a house computer. Now. Is the ECU defective, or is a sensor that connects to the ECU that is causing it to "crash"? Have you ever seen this?
@JoniK1
4 жыл бұрын
Hi! Have you tried extra ground cable from battery to ecu?
@joaopnascimento
4 жыл бұрын
@@JoniK1 Hi. Today I've cleaned the surfaces where the ECU gets the ground from. It was a little dirty. I was hoping it would solve. But not... Yes, an extra ground is the next step. If that won't solve then I'll have to get a new ECU. Thanks for your response.
@JoniK1
4 жыл бұрын
Fuel pump should go on even when key light is on. Have you tried spare key?
@joaopnascimento
4 жыл бұрын
@@JoniK1 The key light, when not starting sometimes stays on and sometimes don't. But in this situation I never ear the fuel pump priming.. Yes, I've tried the spare key.
@joaopnascimento
3 жыл бұрын
Hi Jonik.... I come here to tell you what was the problem. Before the problem started I'd replaced the spark plugs with a new set I've found on the trunk (this is a donated car). After checking everything, including the extra ground to the ECU, I finally related the problem with the spark plug change. I've replaced with new ones and the car has been going OK for 2 month now... How can a defective spark plug cause this? I don't know. My theory is that a spark plug was defective (intermitently shorted) and it would cause the coil to send some kind of signal that would cause the ECU to crash. I'll replace the coils, just in case.
@robyngray1761
6 жыл бұрын
So after you put the self coding ecu in did the car runs great because I need to repair mine cause it's misfiring a lot and I had everything done with the coils but I think it's my ecu but I just wanted to know if the self coding actually works and is it worth the money ??
@JoniK1
6 жыл бұрын
Robyn Gray Yes it works great, still working today 😊
@robyngray1761
6 жыл бұрын
JoniK what year is ur fiat
@JoniK1
6 жыл бұрын
2001 with IAW59F.M2 ecu. There wasn't any available when my ecu went bad so I installed newer IAW59F.M3 ecu 2002->, works fine :)
@JoniK1
6 жыл бұрын
I bought it from Ebay, here's link for both :) www.ebay.com/itm/FIAT-PUNTO-1-2-8V-ECU-IAW59F-M2-PLUG-AND-PLAY-SELF-CODING-12MTH-WARRANTY/253469764822 www.ebay.com/itm/ECU-IAW59F-M3-IAW-59F-M3-HW-303-PLUG-AND-PLAY-SELF-CODING-VIRGIN/263539425917
@robyngray1761
6 жыл бұрын
JoniK my one is m3
@stefanofox4144
2 жыл бұрын
Hai fatto così, per non cambiare chiave,o codice?
@JoniK1
2 жыл бұрын
Here's the parts you need: kzitem.info/news/bejne/xZicy52BhoZ7i34
@Hdbggjjsjnnsnvf
6 жыл бұрын
if you change the ecu, do have to use computer to program or mapping or just plug n start'?
@JoniK1
6 жыл бұрын
I bought self coding ecu from ebay :)
@Hdbggjjsjnnsnvf
6 жыл бұрын
JoniK thanks for your info😁👌
@vamfim199322
7 жыл бұрын
hi. i have a problem with my 8v punto 2. I replace all my ignition, spark plug, coil and cables, but my car still dont work good. On tester apears eror p0352, i check my compression and is good. Do you think its ecu? i have miss fire on piston number 2 and the fuel consumption is very big. 6.4km/l. Thank you!
@JoniK1
7 жыл бұрын
Hi! Have you changed both coils? Mine didn't work well with only one new coil.
@serhatbaran2184
Жыл бұрын
Hi did u solve your problem? Now i have same problem and dont know what to dı😐
@vamfim199322
Жыл бұрын
@@serhatbaran2184 it was the Ecu.
@stefanofox4144
2 жыл бұрын
Perché cambia il posteriore della centralina?
@alankorfanty254
6 жыл бұрын
Anyone got a vidio on how to replace fiat punto manafold and cat convert 2004 6v
@William91W
6 жыл бұрын
Do you have to disconnect the battery first?
@JoniK1
6 жыл бұрын
No :)
@William91W
6 жыл бұрын
@@JoniK1 Then why did you say first disconnect the battery?
@JoniK1
6 жыл бұрын
For safety but there's only two connectors so it's almost impossible to do something wrong :D
@William91W
6 жыл бұрын
@@JoniK1 ah ok thank you. One last thing do you rev the engine to 5rpm 3 times and then turn the car off and back on again?
@JoniK1
6 жыл бұрын
Yes three times 5000rpm (wait until the revs drop to idle) with warm engine, don't work with cold engine. No need to turn off :)
@maxr3022
3 жыл бұрын
Ce da fare apprendimento?
@purechocolate3821
7 жыл бұрын
nice, why'd you replace the ECU though? was it broken?
@JoniK1
7 жыл бұрын
There was mysterious problems, temperature light flashing etc. This fixed almost all, still running a bit rich on cold start in cold weather though.
@fionafagan2181
5 жыл бұрын
T
@slavisakrajisnik5847
3 жыл бұрын
#
@francescochierchia3492
5 жыл бұрын
Hi, I have replaced ecu of my point the engine has problems to a minimum. first with the old ecu the car was fine. here is a video of the defect: kzitem.info/news/bejne/orCt1I1-k4yai44 What do you think is the problem?
@JoniK1
5 жыл бұрын
That's misfire for sure, I would start by replacing spark plugs and leads 😊
Пікірлер: 76