The Frame Issue: If you look, the intake on right side is situated towards front cylinder. Left side the rear. So, the tip of the R point will be beyond the tip of the L point. No fix for that. There is a fix for the L side appearing to angel inward. On R (brake peddle) side, put stabilizer bar in top, rear cylinder mounting hole to bottom left hole (no threads) intake filter assembly. On L (clutch peddle) side, put stabilizer bar in bottom, front cylinder mounting hole to bottom left hole (no threads) of intake filter assembly. Angles will be near equal. Note: do not tighten bar screws until you've started bolts on cylinder cases and intake assembly.
@israelsantiagojr5056
3 жыл бұрын
You might need to do a ecu flash
@riderhd5545
3 жыл бұрын
It ran fine but it definitely would have fine tune it I'm sure..
@riderhd5545
6 жыл бұрын
Will do thanks
@MICHAELTHOMAS-sy5xs
5 жыл бұрын
I just installed some spikes on my 9 and have the same problem with them being uneven. Did switching them fix it? If so, did u switch just the elbow and spike or switch the adapters also?
@tmotofga
3 жыл бұрын
@@MICHAELTHOMAS-sy5xs I just used a diff cylinder hole on left side.
@alanburgess7519
6 жыл бұрын
They're on the wrong sides. Swap them and they'll be even.
Пікірлер: 9