Hello sir... I have masso... I want to ask from where I can buy this probe?? And also please state is it PNP or NPN?
@kiwidude8931
4 жыл бұрын
Is this a new version - not been on my mill for months - have I missed much 😅
@ramkitty
4 жыл бұрын
can you simply jog over and grab the other corner and have it calculate the center
@testyourdesign233
4 жыл бұрын
Thanks for sharing your experience. Which Masso are you using?
@ramkitty
4 жыл бұрын
Am not but I also have an x3 that's in storage about to be setup and upgraded I am comparing to linuxcnc and mach3 (4) since this hugely impacts board selections I am researching pros and cons documentation is masso biggest con
@testyourdesign233
4 жыл бұрын
@@ramkitty each controller is slightly different but many features are the same. Masso is simpler to setup and has many good features but no controller can do it all. I have three Massos and a Mach 3 so I know this can be a difficult decision.
@ramkitty
4 жыл бұрын
Your setup looks great similar to what I am intending. I like the masso for dumping the need for a pc. I got the machine hardware in just need better drivers up and a lot has changed in 10 years
@kiwidude8931
4 жыл бұрын
Is this a new version - not been on my mill for months - have I missed much 😅
@testyourdesign233
4 жыл бұрын
It's been there since probing menu was added but it's not explained anywhere so I thought I would demonstrate how to do it.
Пікірлер: 9