Good Information Thank You For Taking The Time To Make This Video I'm Not Criticizing Or Tryna Tell You What To Do But Maybe You Can Put The Specific Feeler Gauge To Use On The Top And Cotton In The Description, Or As A Pinned Comment So That This Is The Only Video Fellas Will Need To Watch To Have All The Information To Do It Their selves Thank You Again
@johncissel5481
Жыл бұрын
My T doesn't line up with my holes. Should I keep spinning fly wheel until both the T and the large hole is on top?
@GY6-SCOOTERS
2 жыл бұрын
Nice tutorial video sir ...!🙂👍say I'm having a hard time with finding a replacement dowel pin for my gy6 50cc boom pyt revolution scooter ☹ I replaced my rocker cage assembly I ended up smashing the bottom left hand corner dowel pin I've ordered 2 different size dowel pins already one is I.d 7mm o.d 8mm it fits the hole on the rocker assembly perfectly but I cannot get it to go on the mounting bolt while on the other hand the other dowel pin was to big/round it was the i.d 8mm I'm not sure how to go about replacing this dowel can you please give me some advice
@popcorn5968
3 жыл бұрын
Sir, i have a Kymco Dink 150 and somehow similar to gy6. I cant get it to start. It has kick backs when kick starting. Should the T mark be TDC? Because when i check mine, my T mark is 2-3mm before TDC
@julianarodriguez3635
2 жыл бұрын
How about for a Honda beat 125cc in the Philippines 🇵🇭
@wesleykerrigan7198
2 жыл бұрын
So it's the mark below the T or right on the T ?
@Firan25
2 жыл бұрын
I would say. If you see the T. Check the cog if the big hole is at the top and the other 2 are flush you're good. If you see the T but not the big hole on the cog keep going till you see the T again and look again.
Пікірлер: 11