i have one of those hanging on the garage wall. it is a bit bigger, 758g. i did use it in the past and it is no fun. it is very heavy.
@user-hn9qg5qm3o
9 ай бұрын
How in the world did you get into the motor on this? I can’t seem to figure out how to take off the outside housing to then be able to remove the cylinder bolts.
@jonparkmac
9 ай бұрын
Checkout the second video in this playlist. Have to remove flywheel and clutch both sides and reveal the screws. I had to use an impact driver. Next time I would use heat first
@user-hn9qg5qm3o
9 ай бұрын
@@jonparkmac I can't even get the flywheel off the crankshaft! I think they have the thing welded on or something because I've tap-tap-tapped on it and nothing happens, not to mention how they have the housing around the flywheel makes it near impossible to pry up on it.
@jonparkmac
9 ай бұрын
@@user-hn9qg5qm3oyeah, need a puller that you can position the claws under the flywheel, working with openings in the housing and sliding them around and finally putting the puller bar back into the claws.
@user-hn9qg5qm3o
9 ай бұрын
@@jonparkmac I managed to get the flywheel off finally with that same puller tool you used. Thanks so much for showing that! Now if I can figure out why it will not fire. Mine has spark, feels like it has pretty descent compression, and I thought it was getting gas from the tank to the carburetor, but maybe something is off in the fuel supply system? Even when I put a little starting fluid in the top of cylinder where the spark plug goes it still won’t pop for me 🤷🏼♂️
@jonparkmac
9 ай бұрын
@user-hn9qg5qm3o try putting a cap full of 40:1 fuel in the hole and pull it 5 times. Is the spark a strong spark? Check the plug gap too, but need a good blue bright spark. When you pull, should feel good resistance ..sort of hard to pull ..if it has good compression
Пікірлер: 12