Thanks for sharing your build. I'm still printing my frame parts for mine.
@aaronreineking2173
Жыл бұрын
You’re welcome. It’s a fun build! Hope you enjoy yours!
@Leviathan3DPrinting
Жыл бұрын
Amazing! Keep up the awesome builds.
@aaronreineking2173
Жыл бұрын
It’s Rolohaun3D’s design and Kanrog’s mod. I just put the parts together. But I definitely appreciate it.
@Gulsifer
Жыл бұрын
Awesome man 🎉
@aaronreineking2173
Жыл бұрын
Thanks 😁
@livedeliciously
Жыл бұрын
These printers are going to become the new Ender.
@aaronreineking2173
Жыл бұрын
Rolohaun does seem to be having an increased following! I’m seeing them getting mentioned more and more by some of the bigger 3D printing KZitem channels.
@chrismckay3868
10 ай бұрын
Oddly i am using an ender for parts for the 235 i am building.. specially for parts interchangeability with my enders lol
@tomernatan7134
Жыл бұрын
Great success
@aaronreineking2173
Жыл бұрын
Thanks
@curtiswiancko693
Жыл бұрын
That's awesome
@aaronreineking2173
Жыл бұрын
Thanks!
@Tcromb
Жыл бұрын
This looks awesome! I'm hoping to make the same thing. Is there a designated BOM for this or did you have to modify things very much?
@aaronreineking2173
Жыл бұрын
The BOM is the same as the stock build except for lengthened linear rods. 360mm for the 8mm x and y rods. And as long as you want to go for the 12mm z rods. And the bed is different too I suppose.
@AndrewAHayes
Жыл бұрын
Which bed plate and heater did you choose? the Rook looksd awesome by the way, Im planning on building one myself
@aaronreineking2173
Жыл бұрын
It’s an Ender 3 bed that comes with its own heater. I have a Wham Bam build plate and magnet on it. For mounting it, I designed a cross piece that attaches to the gantry. The mod is in the Rook 180 mods section on Rolohaun’s discord.
@NotAWiseGuy76
Жыл бұрын
Hey, nice one! What bed do you use?
@aaronreineking2173
Жыл бұрын
It’s a stock Ender 3 bed. I put the mount .stl in the mods section of Rolohaun’s discord.
@tactiti0n
Жыл бұрын
@@aaronreineking2173 👍👍
@firepower9966
Жыл бұрын
have a geeetech ender 3 clone i want to convert to rook 180/235. This is great. Would it be possible to use 8 mm carbon fiber tubes and igus drylin linear bearings for x gantry to allow faster speeds
@aaronreineking2173
Жыл бұрын
I know the Bambu uses carbon rods, but I’d think that once the resin starts wearing, things would get very abrasive. I’m sure you could use the drylin bearings, but I don’t know that you really need it or if it would up the speed at all over what this can already do.
Пікірлер: 22