That was awesome! I am trying to buy a 2275 from a neighbor. Originally built by Bernie Bergman in the 80's. Ill probably tear it down and rebuild it so great to see you do it first.
@jeffetzel850
10 ай бұрын
First run should be higher idle for the cam. Break in. You want crank shaft splashing oil around. 2500 rpm ish
@ddk56vw
10 ай бұрын
This is true on a new cam. This was a rebuild and the cam was good so it was stuck back in. I did however run it for a while at different rpms while fine turning the carbs.
@TwoWheeledHepkat
Жыл бұрын
Nice! Now time to get those new heads on Simon.
@blownaway4371
2 ай бұрын
You can pack it with some Vaseline or Lucas oil stabilizer BEFORE you mount the pump. For whatever engine. It gives it a LOT better sucking oil from the sump.
@VWJawbreaker
Жыл бұрын
First fire up is the most stressful part! Sounds really good 👍
@mschau108
Жыл бұрын
Engine sounds great! 😎
@vayabroder729
Жыл бұрын
You’re absolutely right; Bugpack was bought by EMPI years ago. I’ve experienced this with front suspension parts and a spark plug wire set.
@blakepierman1491
Жыл бұрын
Great build Clint!
@vintage76vipergreenBeetle
Жыл бұрын
Sounds good. 👍
@TyScott85
8 ай бұрын
Sounds great!
@Fahrfrumlosin
Жыл бұрын
Those new cb heads you got, are you running outta the box or do you still lap the valves?
@ddk56vw
Жыл бұрын
Since none of the valves leaked when I measured the combustion chambers CC I will be running them out of the box.
@garyjones2582
Жыл бұрын
Take a couple bucks and either build or buy you a decent engine run stand before it dumps all your hard work on the floor and ruins your day... BTW, nice looking engine...
@Vwbugthingz74
3 ай бұрын
Bug pack cam?
@robharris9656
2 ай бұрын
did you figure out why the smoke?
@ddk56vw
2 ай бұрын
@@robharris9656 just extra oil in the cylinders from installation.
@travisstuber
11 ай бұрын
Can u shoot me over the parts used on this motor I’m thinking about building one for my buggy
@ddk56vw
11 ай бұрын
It's your basic 2276cc engine. 82mm crank 94mm pistons and 5.5 H bream rods. The cam is close to a fk 8 with 1.4 to 1 rockers and the heads I think were done by brothers machine but CB wedge ports would work too. Carbs are weber 48mm IDF's.
@Gokywildcats11
7 ай бұрын
Cost to build this
@ddk56vw
7 ай бұрын
It's hard to say. The price would depend on how and where you source your parts. Whether you went with all new, used or a mix of parts. Are you going to do it yourself or have someone do it for you. Thanks for watching 🤠😎
Пікірлер: 23