This is a touch screen plc setup from Hatch on Castboolits forum and it is running the 100 pound casting pot/machine that I built. Others have used the same pneumatic parts to automate the commercially made mastercaster, but I decided to change the orientation of the cylinder for the lead pour and placed the large cylinder outside of the area where lead tends to drip. The machine is setup for 2 cavity brass NOE molds and is shown with the .401 160 rn pb which will be powder coated and used in my XD Service 4" bitone which is a tricked out limited 10 gun. The valve drips with higher heat and the first little drip that falls into the mold will create a wrinkled nose. Using lower temperature and allowing the mold to stay hot enough, produces good boolits. This video was shot while I was still getting the hang of the machine and many of those boolits went back in the pot.
- 6 жыл бұрын
First run of Hatch-automated bullet casting machine
- Рет қаралды 26,809
Пікірлер: 17