Great vlog again Darren. As suggested get the correct unit to power flashers and be rid of wired in resistors especially if their getting hot. Start with battery earth to frame and clean it then all the earth points you can see on the bike, Dremel do a nice little flapper wheel (none abrasive) for cleaning surfaces. Stay well and good luck with MOT.
@SAVING_ICONIC_MACHINES
3 ай бұрын
Well done bro on the consistent content keep up the good work!! ❤
@oodiddy9778
3 ай бұрын
on the indicator issue get rig of all the indicator resistors and just buy an adjustible flasher unit. then you can run any indicators you like and not have them flashing at a millionn flashes per second.
@kevintyler7900
3 ай бұрын
I agree here. A LED compatible Flasher unit might sort this problem but I think you would need to remove the diodes to stock wiring.
@Getreadyforthelunch
3 ай бұрын
Could been water or rust on the electrics a blowing chip or resist
Пікірлер: 6