Hello everyone,
As promised in the video where I fitted the Renthal bars using the brilliantly engineered top yoke conversion from Moto-CNC (If you haven't seen that video then the link is displayed as a card within the video), I said that I would be fitting a new set of bar-ends and here they are!
R&G Racing bar-ends specifically made to fit the Renthal bars that I fitted during the conversion, but are also a direct fit to LSL bars, stock 2008 and later Ducati 848 bars, Ducati Monster 1200, 2014 model years, Ducati Monster 1200S, 2014 model years and 2014 KTM RC125/200 with cut grips.
Link below.
ebay.us/afQM06
All links to products are affiliate links for which I will receive a small commission on any purchase made, at no additional cost to you.
I hope that you enjoyed this video.
Don't forget to like subscribe and comment for future content from Kev's Shed!
If you wish to offer support to my channel and enable me to continue to bring you quality content then please check out my Patreon page at the following link - www.patreon.co... - Thank you.
Join me on the socials at the following links
Kev's Shed on Facebook - / 561477094498994
Kev's Shed on Instagram - / kevins_shed
Kev's Shed on Twitter - / catakev79
Негізгі бет Fitting R&G Racing Bar End With Slider Protection to The VFR800 Renthal Bar Conversion
Пікірлер: 17