All the TPU prints on the TinyTrainer shown are designed by me (except the battery tray, but I did modify that design to fit the packs I use) and most are available at www.thingivers...
The props in the video were literally my 2nd iteration, the first was a single bi-blade just to test if it would produce thrust, hence why I put "test" in the stl filenames.
If you're crazy enough to try them, at your own risk:
Tri-blade versions:
www.haku.co.uk/...
www.haku.co.uk/...
Bi-blade versions:
www.haku.co.uk/...
www.haku.co.uk/...
I printed them in TPU without support on my Prusa i3 Mk3, 0.2mm layer height, perimeters set to 6 so the hub is printed solid, and also set retract to 4mm, z-lift to 0mm, and cooling fan at 100% all the time.
I have tweaked the design slightly so it prints easier and the tips don't have overhang issues like the first version, but won't put the stl's out until I've managed to give them a test.
This got featured on Joshua Bardwell's FPV news livestream: • DJI drone gets FCC hac...
Негізгі бет Five33 TinyTrainer with 3D printed TPU props
No video
Пікірлер: 57