Yea it fixed my idle issue but when you go to ride it your rpm’s are all over the place
@juandrefourie4339
2 жыл бұрын
Thanks for the video My bike struggles with idling sometimes, i have a 2007 gsxr 600, this is a new problem with the bike and we have checked some others stuff to see if that was the issue but I think this can be it, the bike just would shut of when coming to a stop, and it feels like whenever this happens the revs drop n little bit faster, and then sometimes it idles very low like 500, can it be that the hoze is clogged or can I clean the idling valve?
@dennystoutzenberger1212
2 ай бұрын
I'm having idle surge issues on my GSXS 1000. And have no clue what is causing it. Bike runs great just at idle it surges up and down
@thnkngreen
3 ай бұрын
I have same issue. Bike struggles to start
@folerx
3 ай бұрын
what this rrrrrrrr like zip tie sound at 11:42 when rpm drops, at 3krpm?
@jacobmoreno40
7 ай бұрын
What other OBD tool are out there besides Healtech?
@carolynstone5772
7 ай бұрын
I have a question are you familiar with the 08 boulevard c50
@alecborden1448
4 ай бұрын
I have the same bike same color same set up (STVA) secondary throttle valve/ butterfly delete two brothers slip on Except I've replaced every sensor I could think of spark plugs cleaned the throttle bodies and fuel injectors, replaced ISC, clutch switch had the bike dyno tuned and flashed idle rpm increased to 1400 and still to no prevail the thing will idle for 30 sec or so and then die even If I ride and come to a stop it dies, unless I hold the throttle open and warm the bike above 160 F I've ordered the heal tech OBD tool and reset the ISC and played around with it but I cant figure the damn thing out its been over a year now... only thing left I could think of is a new rectifier and stator and possibly. I just want to get it running right so I can sell the thing without screwing someone else over LOL and then get a newer bike.
@alexmujkic3227
2 жыл бұрын
2008 gsxr 1000 I have the same problem when I pinch the hose (restrict air) it runs good. If I block it off or if I let it be it revs up then down or sometimes shut off. I might try and ISC reset
@zkiko24
Жыл бұрын
Did u find a solution other than restricting air in the vac hose?
@alexmujkic3227
Жыл бұрын
@@zkiko24 I did not, I ended up finding a rubber cap drilled a smaller hole to restrict some air and the bike has ran good ever since
@zkiko24
Жыл бұрын
@@alexmujkic3227 thank you i did the same, today i will try to reset the pre set values of the valve via an obd tool, i will tel you if it works
@zkiko24
Жыл бұрын
@@alexmujkic3227 sadly for me it didnt work , but the obd tests show that the isc work fine, they raised my idle when ecu flash which seems to cause issue with the isc, i will try to go again to make it 1150rpm like before (instead of the targeted 1250)
@doubledarklivedirect3619
2 жыл бұрын
Yo I'm from vallejo I got 250rkawaski man it's just one thing or another I have to use quick start,then it run idles Hella then it cuts off???
@eastoaklandsartiebo-bo6718
3 ай бұрын
Mines doing the same but once I try to rev it it shuts off
@eastoaklandsartiebo-bo6718
2 ай бұрын
FROM THE LOOKS OF IT NOBODY BIKE WAS FIXED DOING THIS. IT DID GET MY BIKE TO IDLE AND I WAS ABLE TO ACTUALLY HIT THE THROTTLE BUT WHEN I TOLK IT FOR A TEST DRIVE 👎🏾 ITS MORE TO IT THAN WHATS SEEN HERE
@bryanhayward706
3 жыл бұрын
Dude im in Hamilton with same problem
@MRFIXITAPPRENTICE
Жыл бұрын
Need ya assistance
@Bike-life252
7 ай бұрын
Suzuki gsxr 750 2003 k3 bogging out when applying throttle. Changed so much as well. Can you help, please?
@eastoaklandsartiebo-bo6718
3 ай бұрын
Mines doing the exact same thing. Your about the only other person I found this issue being the same. Hard start and when finally idling I engage the throttle and it immediately shuts off.
Пікірлер: 26