If you have a cnc machine that has a pump integrated can you by pass the small pump in the chiller as its not needed and still set the temp on the control.
@khalidlamrani6849
5 ай бұрын
Thanks for your video, it is very helpful. The motor pump was blocking the machine from normal start. But in my case, I opened the pump and found a piece of dust blocking the fan from spining. I tested the motor with a 24v power supply and worked like a sharme. My CO2 Laser machine is working fine now without replacing anything. Thanks again my friend.
@bradfader691
7 ай бұрын
Mine burnt up after a month. Replaced it with a condensate pump from a furnace lol it worked great!
@alexb.9381
2 жыл бұрын
Link where I can buy the water pump please
@mytuberforyou
Жыл бұрын
The all-important question here is where to source a pump. Mine appears to be weak, it's not trupping the flow sensor on the laser, and although some water is circulationg, the green light is not coming on.
@thelazerwhisperer
Жыл бұрын
What would cause a cw5200 to keep tripping the circuit breaker in the premises? It Powers on for 20 seconds or so then trips the circuit breaker in the premises
@davva360
2 жыл бұрын
Ours the display is on but I don’t think the pump is running but not sure how to confirm. I took the outflow pipe off and nothing pumps out so I don’t think the pump is working
Пікірлер: 9