When I tried to print the flower pot in the previous video, my 3D printer would stop randomly around 5 minutes in or sometimes right at the end. The issue turned out to be the bed's thermistor cable that reports the temperature to the main board. I saw drops in the temperature graphs. Octoprint would throw a MINTEMP error after too many drops. When I took apart the cables, the thermistor cable's connector fell apart in my hands. So after I replaced the cables with a new set, it all started working again! To celebrate, I printed out a banana cage for my bike, but it didn't fit on my unusual bike. Oh well!
Replacing The Lulzbot Mini 1.03 Bed Cables Workflow
ohai.lulzbot.c...
Banana holder for bike
www.thingivers...
Негізгі бет Fixing the 3D Printer Thermistor Cable!
Пікірлер: 5