Flair the ends of the brass tube out and deburr the inside edges. You could always use a heat gun to get the brass to expand a bit. Or sand the diameter of the plastic pin down
@JB-996
6 ай бұрын
I had the dreaded pedal wobble on my cable throttle 986. I did a pretty simple fix I found on Rennlist. All it took was a small grub screw to be screwed in on one of those tabs on the rear of the pedal (near the wobbly bit). Simple to do and been rock solid ever since.
@gregc8822
3 ай бұрын
For anyone doing this. Be sure to use thread lock on the 2x 3mm hex bolts that attach the billet hinge to the pedal - mine worked loose.
@miguellapa6868
6 ай бұрын
Great job 👏 👍 👌 You have to give a lesson to those engineers 🤦♂️
@ratspeedgarage
6 ай бұрын
Wow that gave me heartburn 😮
@WoodShop23
4 ай бұрын
Predator reference wasn't un noticed mate... Great video I'm going to get one and give myself a headache 🤣
@ForensicDetailing
4 ай бұрын
love predator :)
@neilbruce9614
6 ай бұрын
Can you not heat the brass in hot water, maybe a bit of silicone grease on the plastic
@philclare5005
6 ай бұрын
Great video Jon, i did mine a couple of weeks ago (later car electronic throttle). My brass sleeve fitted ok, i had no need to dress the plastic, maybe the two types of throttle are slightly different? I did find the reassembly a pain though, getting the cable inside to locate with everything else at the same time was a nightmare😅
@Blackcat118118
6 ай бұрын
When can we expect the best all in one polish video 😮❤
Пікірлер: 12