So I found this video during my deep dive in researching the FJ seat holes and saw exactly what I needed to see... I plan to replace both covers and both pads with new. When you had the frame stripped down if you look at the back frame at the lower part of the bolster there is a round rod welded to it with a sharp 90 degree bend in it and that little corner of the rod is what is poking through the foam pad and causing the hole to wear in the both the pad and the cover... It honestly looks like you can just cut that rod off with an angle grinder and once you install new foam and cover it cannot poke through again... As for the bottom cover hole I'm looking at reinforcing the new cover from the back side.
@MrGunnerru
2 жыл бұрын
Cool thx gonna take mine in to a shop needs all the cushions swapped.
@chrisfort7340
2 жыл бұрын
Thank you! Good post! My FJ is in good shape but I want to remove the seat skins to install an eBay heated seat kit. Next time, if I have time I might paint those frames to prevent future rust. Thanks again! Chris
@Fourwheeljive
2 жыл бұрын
My ‘08 is worn out on the upper edge like yours. I need to replace mine too. Thanx for showing me what’s inside.
@lonesomecricket7721
3 жыл бұрын
Thanks for posting. 👍🏻
@originalengot
3 жыл бұрын
think we have the same fj from rats infestation, headliner rsts nest , cabin air filter nest, Aui filter nest, roof rack leak , same seat tear bottom and back support
@DadsGotADeal
3 жыл бұрын
GamerToby- Roblox and more! Bro! What state?
@jaimegarcia213
2 жыл бұрын
Does your seat not have the passanger weight sensor
Пікірлер: 8