Repair procedure that I followed:
Make safe by cutting power at circuit breaker and local switch near pump. check that pump is de-energized by attempting to to turn pump on with timer switch.
Remove the pump housing.
Clean inside of housing thoroughly with soap and water.
Clean area around housing crack with alcohol.
Apply Flex Tape over crack on inside of housing.
Apply pressure to the tape by pressing it with fingers.
Replace pump casing.
Re-energize pump
Repaired on 8/31/23.
Repair lasted until: TBD
Notes: Pump housing bolts are tight and difficult to loosen. I assume Loctite was used doing OEM assembly.
Негізгі бет Flex Tape sealed the leak on the pump casing of the Polaris PB4SQ
Пікірлер: 5