This is my second RC video! This was the very first scratch built plane that I have built in which actually flies well and it is also my first FliteTest build! This build project did last a few months for me but I am glad that I documented and am able to share the experience with others through this video. Information about my plane specs as well as electronics and components that I used will be listed below as well as FliteTest's website where you can find more information. If you have any questions, feel free to ask below in the comments!
🞇Information: I printed the plans out from flitetest.com and cut them out onto 20in x 30in Adam's Readi board from the dollar store. This build took about 2 and a half sheets (3 sheets) of foamboard and weighed about 550g before I added by custom modifications. When I painted the plane, it added 30g, when I added the landing gear, it added about 125g and when I added my own 3D printed powerpod and other electronics, it added another about 200g, bringing the total weight to around 850g which is a lot heavier than it should be but it still worked. Thanks for watching this video, and I hope to see you guys around in upcoming videos!
🞇Parts that I used in this build:
-9g Servos (sg90)
-2200mAh 3s Ovonic Battery (25C)
-Standard 30A ESC
-Standard Amazon 2212 1000kv Motor
-10in propeller (you could probably use 9in or 8in too)
Flysky i6x Transmitter and FS ia10b Reciever
🞇Social Medias:
-KZitem - kzitem.info/rock/NF7...
Twitter / snapperwamper
-Instagram - / wampersnapper
-Fiverr - www.fiverr.com/wampersnapper
🞇Check out my last video: • VolantexRC TrainStar A...
🞇(Currently as of this video being uploaded at 304 subscribers!)
#RoadTo400
#WamperSnapper
#RCPlanes
🞇Flying this Simple Scout for a second time: (No video yet)
-------------------------------------------------------------------------------------------------------------------------
🞇Links to this plane:
-FliteTest (New Maker Foam): store.flitetest.com/flite-tes...
-FliteTest (Old Maker Foam): store.flitetest.com/flite-tes...
🞇FliteTest plans for Simple Scout: s3.amazonaws.com/plans.flitete...
🞇Link to my first plane on Amazon: www.amazon.com/HobbyZone-Airp...
🞇Link to my second plane on Amazon (PNP): www.amazon.com/VOLANTEXRC-Air...
-------------------------------------------------------------------------------------------------------------------------
Chapters:
0:00 Intro
0:24 Cutting out plans
0:38 Cutting out foam pieces
1:33 Assembling parts
2:37 Ready to paint
2:44 Green spray-paint
3:00 Black spray-paint
3:17 Adding decals
3:30 Applying clear-coat (spray-paint)
3:40 Landing gear setup/configuration
4:41 Wiring servo leads
4:49 Pre-maiden flight test
5:08 Maiden flight
6:01 Re-maiden flight
7:49 Outro
Негізгі бет Ғылым және технология FliteTest Simple Scout - Build (#1) and Maiden Flight
Пікірлер: 13