Howdy!
In today's video Kyle will be flying cutting a Triumph cylinder base gasket surface
The current cases at hand have both high and low spots including a raised “lip” where the two crankcase halves meet..
Fly cutting the base gasket surface will address this issue
If you are curious to know the process of what goes into fly cutting and setting up the cases, I recommend watching todays video
This specific engine is a 1966 Triumph 500 (unit)..
Also, I would like to give a big shoutout to Mitutoyo, Shars & Starrett
Thank you for watching!
www.classicbritishspares.com/...
#classicbritishspares #triumph #starrett #mitutoyo #shars
Негізгі бет Fly Cutting A Triumph Base Gasket Surface
Пікірлер: 8