Ended up adding a 5 cent piece ( Australian ) in the front of the battery bay of mine , and yes it is the 2s brushless version .
@tinkerzlab
2 ай бұрын
I'm glad you got one. Awesome airframe and I'm having a blast with it.
@patrickhicks4426
2 ай бұрын
Glad I ran across this channel new to the hobby have ordered a jet waiting on it to come in but I want any have you seen the new FX 9631 RC jet and do you have any information on it
@tinkerzlab
2 ай бұрын
Thank You! We also have Ground Control RC: www.youtube.com/@GroundControlRC This is a fun little jet and the airframe is fantastic but they did put a problematic ESC in it. I haven't seen the FX9631 although I did try to find some info on it. I did find some videos of the FX9630 which looks like a similar setup. From what I could understand it's a brushless ducted fan 2S system. Sound like it might be fun ;-)
@eu.mariolima
17 күн бұрын
Any hardware or soldering are needed to bind TX16S with QF009? Or the 4-1 bind directly
@tinkerzlab
17 күн бұрын
Nothing needed. Protocol = MT99xx / H7 6G / 3D = CH5 This protocol worked with mine.
@_Danilo_L.
2 ай бұрын
my QF009 also has motor cut on most flights i do. I flight this modell since one month, and not only motor cuts, also hot LIPO and bad reactions by full speed flight. It is a little bit agressive, i think cause the mix of aillerons and elevator, an cheap solution.
@tinkerzlab
2 ай бұрын
I had a hard time with the controls using the Stock TX and had to adjust the linkage to make the controls easier. It handles nicely with a full size TX. It's a great airframe but I'm replacing the electronics on mine due to the constant motor cuts.
@mcemtpockets1775
2 ай бұрын
I would fly every day if i had a spot like that!
@mcemtpockets1775
2 ай бұрын
Very good info.
@mcemtpockets1775
2 ай бұрын
4:21 man man man... hope the air works
@mcemtpockets1775
2 ай бұрын
Thanks for sharing
@Wezziak
21 күн бұрын
What is difference betwen coolbank QF009 and QF009 ?
@tinkerzlab
21 күн бұрын
The only difference I know of is color.
@Wezziak
21 күн бұрын
@@tinkerzlab so i can buy the cheaper one
@tinkerzlab
21 күн бұрын
@@Wezziak I don't have both but the specs look to be the same. Whether or not they use the exact same board and protocol I can't confirm.
@mcemtpockets1775
Күн бұрын
I exp motor cut. I thought it was the angle of the craft! Because i only heard it and did not feel any difference or visibly notice. but I do hear the sound start and stop.. but not like a fade.
@tinkerzlab
Күн бұрын
@@mcemtpockets1775 Yes, mine was very quick and didn't cause any issues just very annoying.
Пікірлер: 22