I'm considering buying a 450 V3 and this is a very helpful video! I have owned the DJI Phantom and Traxxas Aton drones and always flew these in ATTI mode without the restrictive and less agile GPS mode.
@bradyates7046
Ай бұрын
I have blinking yellow light on gps switch. as you say it indoors at this time . I need to see if it change to green outside today.if it work I will not upgrade the gps unit.
@charlescoby5741
10 ай бұрын
You going to make a flight, with the changes?
@Maltojo
9 ай бұрын
Thanks!! What exactly is ATTi mode, as compared to 3D or Normal or 6G? I hear about ATT in different places but I don't quite get it yet. :)
@CRUZROYHelicopters
9 ай бұрын
its 1400us its between GPS and home mode, its stable without the gps , so it will stay level but drift
@RGCbaseace
23 күн бұрын
I did the factor reset now gps and atti have no difference like it did like yours i think mine is set now will try tomorrow
@mariopires4391
23 күн бұрын
I did exactly as you explain in this Video Clip (3D-»ATTI=1400) so it was expected that my FW450 would actually maintain the Altitude BUT THAT IS NOT HAPPENING. If I don't control the "altitude" with the Colectivo, the Heli will fall to the ground. Can my Friend give me an explanation for this? Thank you very much for your attention. Mario
@RGCbaseace
23 күн бұрын
Friend you and me both
@RGCbaseace
23 күн бұрын
I think we got to change the pitch setting their is a difference when you switch between the two ?
@RGCbaseace
26 күн бұрын
Been trying this on mine but atti seems just like 3d to me as mine will drop if not fast enough on the left stick she doesn't stay at any hight but is spot on in gps
@CRUZROYHelicopters
26 күн бұрын
need a computer and a good outside calibration
@RGCbaseace
26 күн бұрын
@CRUZROYHelicopters doing that right now lol. Seems to gain a bit of collective between gps and atti that normal ? It sure didn't climb last time between gps and atti gps is rock solid All looks good gonna try
@RGCbaseace
26 күн бұрын
Ok tried it again in just gps all is still good but I think I damaged the belt last time it came down fast I switched back and gave it up it made a unhappy noise I suspect a few belt teeth are gone
@jeffkraus1457
26 күн бұрын
What is ATTI MODE? Also, please give me a down and dirty tutorial on binding my Flysky FS-i6s Radio from my 450 to the FlyWing BELL-206 Thanks
@CRUZROYHelicopters
25 күн бұрын
you have to add models, that radio only has 5
@CRUZROYHelicopters
25 күн бұрын
kzitem.info/news/bejne/z6Fty3eIaV-Ap34
@CRUZROYHelicopters
25 күн бұрын
once you follow the add model video, follow this one to make settings the same . kzitem.info/news/bejne/26ah1ml9ZnuLrH4
@CRUZROYHelicopters
25 күн бұрын
atti mode, is heli will keep height but lose gps
@alexlucyrep9948
Ай бұрын
each time i put mine in atti mode it drops from the sky have to put more up on controller yes blinking red
@danduer1174
Ай бұрын
If it is dropping you are in 6G mode you have to go on the software and hit the factory reset button to completely reset the flight controller to get ATT mode especially if your H1 is the heli version but caution when you hit the factory reset make sure that you have either wrote down or took a screenshot of all your previous parameters and swash plate numbers before you hit that factory reset Hope that helps you
@alexlucyrep9948
Ай бұрын
@@danduer1174 thanks will do taken all photos and will reset it next week after fun fly week end xx
@danduer1174
Ай бұрын
And I also forgot to mention my friend when you go on the software it has to be version 2.0 software
@alexlucyrep9948
Ай бұрын
@@danduer1174 ok thanks again for reply will look what vir iv got doing it next week many thanks x just looked yes got vir 2.0
@danduer1174
Ай бұрын
Now when you get done setting to factory default settings in 2.0 and you get all your parameters and everything reset when you get done have it in 3D mode which is the blue light if the tail motor does not start when you unlock it then you have to go to version one 1.81 and restart the tail motor in that version I know it's crazy but I've been through all this that's how you have to do it if your tail motor starts in 3D mode then you're fine
Пікірлер: 24