I hate to say this... but... I like to see guys like y'all, crash, so when I crash (which happens alot) I dont feel so bad 😜😁😎
@RCPlaneReviewer
2 жыл бұрын
Hahahhaaha yeah man! We post this stuff too because we're normal people who have the same problems! Lol a good crash is humbling too 🤣
@joshuaburgess4730
2 жыл бұрын
80mm f18 was about a 1.7 second flight! Broke two records. ! Most expensive plane and shortest flight. Was a maiden to!
@renaldolama9517
3 ай бұрын
This is why I used a separate receiver battery, no matter how much weight it adds.
@rickythrower5892
2 жыл бұрын
This is for the pilot, there are a lot of comments, I want you to remember when you hit the landing gear you had nothing, your control surfaces were locked and you had no throttle no up elevator no ailerons no rudder, the rudder was locked in a solid position because when you have a brown out any control surface can get locked in one position but at the time you can't do anything to counter the out-of-control plane or jet because you don't have any control of it. Always remember you tried to save it but no control surface would work.
@ProKr3w
2 жыл бұрын
cant wait to do a high alpha landing with this!!!
@thercf16guy35
2 жыл бұрын
Whoa! Nothing could be done to save that. What a violent roll
@RCPlaneReviewer
2 жыл бұрын
She was nasty!!!
@robertwong2412
Жыл бұрын
When you hit the landing gear, it starts pulling amps from the bec. This takes powers away from other servos if the bec couldn't supply constant 5v even though it's switch mode (I hope it is). Count the number of servos you have and the landing gear and you could expect the amp draw to likely exceed what the BEC is capable of putting out. My advice to anyone flying jets with retracts and servos exceeding 3 (especially standard servos) is to get a separate dedicated bec. Don't rely on the one in the ESC. Especially digital servos, they eat up amps. Failure to supply constant 5v could cause your servo to fail or receiver to brown out.
@RCPlaneReviewer
Жыл бұрын
A good possibility
@victorrcjets7660
2 жыл бұрын
It looked like it hit an invisible wall!
@velcro62
2 жыл бұрын
Did you say Bowl Effect?
@killowattair
2 жыл бұрын
The way it corkscrewed into the ground I would guess locked right full rudder
@RCPlaneReviewer
2 жыл бұрын
Haven't thought about that!
@ppmd8909
2 жыл бұрын
Agreed
@rickythrower5892
2 жыл бұрын
Brown out! I'd be willing to bet you don't have a separate BEC. without one sometimes there will be to much draw when you hit the landing gear which causes a brown out.
@manicfour
2 жыл бұрын
Explain to me please. I have a MiG29 and ive read something about too much draw when operating the landing gear at the end that results in a crash. It has two BEC'S. One is for thrust of one fan and the other for the other along power for the blue box as well. So do I meed to somehow add another smaller battery to power the blue box alone?
@rickythrower5892
2 жыл бұрын
@@manicfour I have a freewing MiG-29, All RC craft have only one BEC, it is either built into the ESC or you have a separate BEC. Most of us who have been in the hobby for a long time run a outside BEC so that if the ESC fails you still have flight control of your RC aircraft. Also a outside BEC will have a veritable voltage so that if you need more voltage for landing gear lights flaps and so on you will have more voltage when needed saving you from a brown out. Outside BEC's are easy to install, I typically use Castle or ZTW from motion RC
@JakeBullit123
Жыл бұрын
Did he hit the crow spoilers instead of the gear?
@cwwisk
2 жыл бұрын
What if you had parallel lipos stored in the drop tank so it was functional? Good idea or not?
@RCPlaneReviewer
2 жыл бұрын
A neat 💡 idea but the weight would ruin the good Flight characteristics
@gooniac33
2 жыл бұрын
Thats full right rudder deflection.... I think the servo went crazy when you hit the retracts.... what radio are you using?
@RCPlaneReviewer
2 жыл бұрын
Your probably right about this didn't think about that 🤔
@neilhands1708
2 жыл бұрын
Possibly the servos. I've just got mine last week and put it together yesterday, three servo fails before I even maiden it: Rudder servo and one gear door servo not working on initial test, other gear door servo started violently fluttering and then stopped working entirely. Servo's must be crap on it and I'm now apprehensive to fly it in case another one goes. Changing all the servos looks like a major operation due to poor access.
@funflyers8244
11 ай бұрын
Hallo there Well did you find out what the problem was. It did happen to me 4 times now in flight with the gear up. Did replace all 4 servos on the wing and now it did it again....like yours. I FOund out after I was able to land it that the ruder servo was going nuts.
@ljhobbylife
2 жыл бұрын
Something came of that plane, it was too fast of a roll so definitely something came of the plane, something mechanical for sure!!
@offdapace2627
2 жыл бұрын
Would be interesting to see what speeds the freewing Vulcan gets have you clocked it with the speed gun yet ?
@Jeffnc84
2 жыл бұрын
its in the works , Soon grasshopper, sooon!
@RCPlaneReviewer
2 жыл бұрын
Yeah I'm going to see what she's doing next!
@offdapace2627
2 жыл бұрын
@@RCPlaneReviewer mine just come today, I think I’m one of the 1st few people to get it in Thailand, hopefully first flight tomorrow, it’s such a beautiful and sleek jet
@Zmarshall910
2 жыл бұрын
Bummer
@Jeffnc84
2 жыл бұрын
That one stung a little! After watching the video. You can see right as I came down almost level with the trees,it blew over. I’m pretty sure it was wind coming off of the trees to the left of the plane.
@RCPlaneReviewer
2 жыл бұрын
🤷♂️ we'll never know!
@ARGvision
2 жыл бұрын
Still had two good runs. Repair and fly again.
@Jeffnc84
2 жыл бұрын
she will fly again for sure, just ordered the fuse,
@cwwisk
2 жыл бұрын
So if you fly 2 planes side by side to see which is faster fully loaded with ordnance, does that make it a drag race?
@RCPlaneReviewer
2 жыл бұрын
No it makes it a race with an airplane with less drag lol 🤣
@stephaneduke9736
2 жыл бұрын
Hello vous deux !!! je suis vraiment désolé pour vous c un truc dingue ce qui est arrivé .... une question svp es-que l'avion est lui équipé d'un gyroscope ???? merci Stéph de France ...
@Jeffnc84
2 жыл бұрын
No sir. No gyro
@christopherjohnson7137
5 ай бұрын
hey have you flown the 64MM version? I'm wondering how it flies
@RCPlaneReviewer
5 ай бұрын
We have! It's just as nice
@christopherjohnson7137
5 ай бұрын
@@RCPlaneReviewer mine just shipped today, should be here Wednesday
@airlineflyergg
Жыл бұрын
Snap stall is what happened.
@RCPlaneReviewer
Жыл бұрын
No, it was a brownout
@RCINFORMER
Жыл бұрын
It looks like a control surface broke off or went full deflection
@RCPlaneReviewer
Жыл бұрын
Very possible sir!! Very catastrophic and impressive too lol! Appreciate what you do for the hobby!
@nickhayley
2 жыл бұрын
I always fly my planes at me lol. So what's the difference between standing in front of an oncoming rc jet safely and unsafely? Telling people it's "safe". 🤣🤣✈ Love your work :)
@RCPlaneReviewer
2 жыл бұрын
I guess if it doesnt hit you its safe!! if it hits you then its unsafe?? lol cheers mate!
@sendit_rc
Жыл бұрын
that was weird.
@RCPlaneReviewer
Жыл бұрын
It really was and random!!!
@drmrjon
Жыл бұрын
No more excuses, you ran out of battery. That's it!
@RCPlaneReviewer
Жыл бұрын
That's not what happened at all.
@frank-vq4mx
2 жыл бұрын
I don't understand ,why after each crash, the pilot will not assume responsibility. If it was a technical issue or the pilots flying skills, it's still their responsibility !! I have the same jet. I found that the set screws that are used on the ailerons were so loose that the pushrod could slip and even pull out. This is not the manufacturers responsibility it's yours ! All a.r.f models should be thoroughly ,mechanically inspected prior first flight. Most, If not all, a.r.f. models are so poorly assembled, they will fail.
@RCPlaneReviewer
2 жыл бұрын
I agree with you to have to check everytime you go up, but people don't do this, and it's human nature for you to be in disbelief or if you can't explain what happened to blame some type of failure. By the way this isn't a ARF this was a PNP. Arfs are typically balsa planes with no servos motor engines etc. This came plug n play servos and motor installed you just add your radio equipment and batteries. Thanks for watching!!
Пікірлер: 54