PERFORMED BY:
SUBHAM KANU
TEZPUR UNIVERSITY, B.TECH 3RD YEAR
Task:
Perform steady-state simulation in Ansys Fluent.
➢ Plot the following:
1. Velocity at x=0mm, x=100mm, and x=200mm,
2. Velocity contours,
3. Temperature contours,
4. Axial variation of temperature at the bottom wall,
5. Difference in pressure between inlet and outlet,
6. Show the changes that you observe when the termination criterion for all is changed to 10-6
7. Show the changes in temperature plot at the top wall when the mesh size is increased from 200×50 to 400×100.
SHARE AND SUBSCRIBE
#ansys #ansysfluent #ansystutorial #new #trending #cad #CAE #mechanical #mechanicalengineering #engineering
Негізгі бет Forced convection flow and heat transfer in a channel with parabolic inlet velocity profile | ANSYS
Пікірлер