Finally someone knows how to make it done! You should show us how to alignment the timing. Thx
@chrisdavis9556
6 жыл бұрын
Just make sure you hit the flat spot on the crank or your out of luck.
@P21-almilany
6 жыл бұрын
@@chrisdavis9556 Yes sir. Just ordered the tool from Amazon wish me luck
@chrisdavis9556
6 жыл бұрын
And please don't forget to put a large chain wrench on the pulley to help hold it when you torque it down.
@chrisdavis9556
6 жыл бұрын
Any questions just ask
@MarySiebert-fk5ot
Жыл бұрын
I did everything I was supposed lined up using the pin turned the crank til it stopped took valve cover off put cam alignment tool everything was perfectly lined up put back together lined up wouldn't start turned over fine so I took back apart and lined up everything perfectly again pulled off harmonic only difference I see is the newer harmonic balancer ring has more teeth and smaller than the original could that be the cause?
@chrisdavis9556
Жыл бұрын
Yes . It must be the same one . If not it won't start.
@MarySiebert-fk5ot
Жыл бұрын
@@chrisdavis9556 the harmonic balancer look identical except for ring in the back the original had 35 teeth the one I have has over 40 still trying to figure out what the ring does I think it gives a signal to the crankshaft position sensor?
@MarySiebert-fk5ot
Жыл бұрын
So the more teeth would give a wrong signal ?
@chrisdavis9556
Жыл бұрын
Correct.
@MarySiebert-fk5ot
Жыл бұрын
@@chrisdavis9556 thank you because it definitely sounded like it wasn't firing
@Esgee64
4 жыл бұрын
There’s two holes when I looked inside. A shallow one and a deep one.
Пікірлер: 13