Thank you very much for doing this video !! My Jubilee sat outside under a tarp for 7 years and after going through the fuel and ignition the only remaining problem was no 1st and 3rd. Found your video and within 15 minutes repair complete and running strong !! Thanks again !!!
@MattTheWelder
Жыл бұрын
Awesome, glad I could help you out, I still make tractor repair videos. However KZitem has decided to pull my monetization I’ve moved over to pornhub(no joke) because they pay and their community standards are more my style.
@andythaler7486
5 ай бұрын
Thanks, this fixed my tractor!
@MattTheWelder
5 ай бұрын
It’s a common problem, especially up north for some reason. This was the first I saw in Florida out of say 15-20 8ns I’ve bought and sold so far.
@jamesingersoll264
9 ай бұрын
Thank you - the video is succinct and right on .
@MattTheWelder
5 ай бұрын
I thank you for watching.
@hankhoffman3343
9 ай бұрын
How did you get the detent ball out? Mine will not come out. I tried loosened with lube, tweezers, magnet, air pressure. Do you think it could be tapped out from below after you move the rail? HEYELP!!!
@chilibowler
Жыл бұрын
How would one go about getting it to go into second?
@MattTheWelder
Жыл бұрын
2nd gear uses those plates under the 1st/3rd rod.
@billstractorcorner
6 ай бұрын
"More confusing than looking up Caitlyn Jenner's skirt!!" That's a good one!! LOL. Thank you for this tutorial - I'm going to check this on my 8N. You can see about 7 minutes in I have this issue - kzitem.info/news/bejne/mJp-qqWCo4GYhI4
@billstractorcorner
6 ай бұрын
Update - worked like a charm man! I didn't even bother with doing much - just pried her loose and away she goes! I'm missing my detent and spring though... guess I should clean that hole out and find a new one.
@MattTheWelder
5 ай бұрын
@@billstractorcorner You picked the right time of year to mess with it. I’m in Florida and this one came in during the summer. Man it was hot, glad I could help you out, I hate seeing old tractors go to the scrapyard for minor repairs. 🍻
@billf157
5 ай бұрын
@MattTheWelder absolutely, need to save every one we can! No problem with too hot here in Winnipeg most of the time! Cold is another story... thanks again for the how-to!
@rwwells3
2 жыл бұрын
ok..so let's see if I got this. First, polish my rod. Then rotate my shaft. There's a rubber stuck up in the hole deep inside. polish my shaft again. Then tweak my rod back in the hole. Finally my Trannie is ready to go. Does that sum it up?
Пікірлер: 15