You can do this alot easier. Put spindle nut all the way on . Put small 3 jaw puller on end of axle. Run bolt in . Mine came right off.
@maleficum07
Жыл бұрын
To be fair that outer spindle nut very commonly is loose upon tear down….we usually torque them closer to 200ft.Lbs
@MitchelPie
4 күн бұрын
That c clip and the washer and thrust washer were missing from mine on both sides iunno where to find those
@360Sebastian360
8 ай бұрын
very useful, I wish I had seen this sooner.
@salscrofano7870
2 жыл бұрын
I got a massive leak on my 93 front axle I gotta do this now wtf
@nikond90
Жыл бұрын
I have the same problem
@joshbates17
2 жыл бұрын
So the drivers side is the floating side?
@TrollsAreUs1320
2 жыл бұрын
No they are not that hard to get off, that was how easy it is to take my spindle nuts off but I did make sure to torque the inside nut to 40 then back off a 1/4 turn to free the rotor and you put the center spacer then the outer which I left torqued to 40 so my spindle could spin the rotor center and free
Пікірлер: 9