Great help, guys. I'm just about to replace the discs and pads on our scout minibus. Saved me a load of head scratching.
@imphell10
3 жыл бұрын
Just doing discs and pads on a Transit Luton van for the first time. spot on chaps massive help :)
@junkmonkey4596
5 жыл бұрын
Thank you. I’m about to change my Caliper on my transit van and that is a massive help. Mucho Garcia’s
@alandew7150
4 жыл бұрын
Great video, my van just failed MOT with the same problem this is a god send well done both and thank you
@venenodilo8993
Жыл бұрын
I AM SO glad to find this video, thanks a lot guys.
@DSIreland
5 жыл бұрын
Just what I needed thanks lads
@peterbell7553
4 жыл бұрын
Nice video. Well explained and shown what to do. Was a bit confused about the half inch spline socket. I used a half inch bihex with half inch drive. Agreed the 13mm bihex is not snug enough. Also, I thought aluminium and steel reacted together (as in the grease, when it dries out). I used copper grease. Good job though.
@javierguzman172
3 жыл бұрын
Great job. Very meticulous. Thank you for the education
@bogdanalexa1746
6 жыл бұрын
Great video Thanks
@jamiemccort8388
3 жыл бұрын
Great video guys thanks 👍🏻 Just one thing I didn’t understand though, when you installed the ABS ring it didn’t look secure. I assume when it is put on the hub, it will be squeezed secure? That was the only thing I was unsure about, but great video, everything was well explained. Cheers
@adnanaslam9138
3 ай бұрын
Good job 👍
@Ethankeenan02
2 жыл бұрын
I use copper grease never seen ally grease used before
@silvanaklinger8516
3 жыл бұрын
🙏Danke du bist mein Held🙌🎖
@cudntfindagoodname
4 жыл бұрын
Exactly what I was looking for! Thanks guys!!
@kiefergrossett3604
5 жыл бұрын
Just wanted to add that lock tight is always something to use maybe not for you guys but it helps prevent the bolts rattling lose
@Ethankeenan02
2 жыл бұрын
I did a job on a old shogun sport exactly the sane thing happened and needed 2 rear calipers and abs pump
@luckysmiler
6 жыл бұрын
Good video,did you use new hub nut,and i know you needed to fit pad sensor wire ,but the main thing i learnt is the disc and abs ring removel
@jonathanmcclure4381
4 жыл бұрын
What is the torque for the 1/2in. spline bolts? Great video.
@dmc1221
5 жыл бұрын
What about the paper gasket? Can u reuse it? If so would ya use greese on it to seal it?
@Ropeman302
4 жыл бұрын
Spot on thanks 👍👍
@MrMeltedwellies
4 жыл бұрын
You’re welcome 😊
@andrewbassett8210
4 жыл бұрын
Just the video I was looking for, I need to replace the rotors and pads on my VM transit. I’m just wondering if it was a duel wheel or not.? Thanks for a great video.
@paddyici6629
4 жыл бұрын
yeah this is a twin wheel, you can normally tell by the drive shaft he removed, single wheel dont tend to have them
@C63stom
4 жыл бұрын
Good evening do you know the socket size for the main part of the hub it’s huge
@ArnoldClarke
3 жыл бұрын
Changed both rear callipers, lost 600ml brake fluid. Do I have to pump forever?
@madman2666
5 жыл бұрын
hi good vid. what size is the large hub nut ?
@carbo220
3 жыл бұрын
65mm if youre still looking 2 years later lol
@BLTn1
3 жыл бұрын
Doing mine exactly as you've done here, except I changed hub seal.. but when I tighten hub nut the wheel stops spinning freely.. Can't for the life of me work out why. No one I know seems to know either. 🤷♀️Any ideas?
@rabsy
Жыл бұрын
Bit late for you but maybe the spacer isn't in the middle of the hub, between the bearings.
@nps2512
9 ай бұрын
I have to replace the wheel studs on my twin wheel 2007 tranny does anybody know the size of the studs and nuts some kind person helped them self to 5 of my wheel nuts and need to repair the damage
@Ethankeenan02
2 жыл бұрын
Is it the same for a mk7 rwd lwb with 5 studs
@sheldonmcclaflin8904
Жыл бұрын
Go to Medtec67 he shows both front and rear brakes on a single tire 250 Ford Transit.
@1tr1ck
5 жыл бұрын
As if u wouldn change the inner hub seal 😑
@nexpro6985
Жыл бұрын
It was made clear that the vehicle owner was penny-pinching.
@gazsto
4 ай бұрын
What size is that socket? 16:26
@TheEsculap80
15 сағат бұрын
65mm
@user-up7yw4vc5i
Жыл бұрын
50mm centre nut ?
@TheEsculap80
15 сағат бұрын
65 mm
@TheEsculap80
15 сағат бұрын
65mm
@Ethankeenan02
2 жыл бұрын
Lefty tighty righty loosy 🤣🤣
@rabsy
Жыл бұрын
Yes, it is on the left rear hub.
@sheldonmcclaflin8904
Жыл бұрын
Not on the left side of a vehicle, look at older wire wheel vehicles. Left side is right loosy do to rotation
Пікірлер: 45