I guess I can sub. You do forge your tools which makes ya cool enough
@kimfejgin9780
3 жыл бұрын
great work Julian and fabulous video!
@noahfreeman8115
3 жыл бұрын
Always look forward to these vids!
@DmitriIvanov
3 жыл бұрын
Cool lathe man! Seems nice to work on it :)
@cocodij
3 жыл бұрын
Nice video, thanks a lot ! I wish I had see it before forging my hooks, there are things I didn't thought about (angle of the cutting edge, thickness of the rod, ...). I'll guess I'll make some other once ^^ Keep going I like your videos, your turning skills are clearly improving ! :)
@andersswerke5808
3 жыл бұрын
Excellent video, just leave the captions on a little longer and it will be perfect (some of us are old and do not read fast 😂😂)
@jones_trees_and_treen
3 жыл бұрын
Noted!
@rickschuman2926
9 ай бұрын
So the bevel is on the inside for both tools? I have seen elsewhere that the tool for the outside of the bowl should have the bevel on the inside but the tool for the inside should have the bevel on the outside. I expect it has to do with have the proper technique for the tool in hand as much as the configuration of the tool.
@user-mn7bb9nj5y
2 ай бұрын
popular in Japan and Russia worth a look
@AaronTWas
2 жыл бұрын
Very nice work! I am very slowly getting a starter blacksmithing setup together, along with planning a pole lathe, with the intention of making my own tools as you have. Having made both a double bevel hook tool for tip up and tip down work, and with this video making two separate tools for the two tasks, would you recommend that a beginner just make the two tools with opposite bevels instead of the one? You had mentioned getting a lot of catches in your other video with the double bevel tool on the return rotation of the lathe. Again excellent and beautiful videos!
@jones_trees_and_treen
2 жыл бұрын
Thanks! I am sure if I had persevered with the double edged tool it would've been ok. It had some flaws other than just being tricky to use due to the double edge. Having said that, I do feel that if you're forging your own, single edge tools are better. As well as avoiding the return catches, they're also naturally stiffer and seem to make a finer cut for me.
@AaronTWas
2 жыл бұрын
Makes sense, thank you so much!
@traviswright2800
2 жыл бұрын
Do you have any details on the little gas forge you have set up? I'm very interested in a simple forge setup like this one.
@jones_trees_and_treen
2 жыл бұрын
Sure, it's a Gameco gas burner and brick forge kit from an Australian website called artisan supplies. K26 bricks. I've since changed it up a bit, the previous set up was pretty inefficient.
@verdigrissirgidrev4152
2 жыл бұрын
what kinda steel are you using?
@jones_trees_and_treen
2 жыл бұрын
In this video it was an alloy equivalent to 5160, but I've since changed to 16mm O1 (silversteel)
@johnjude2685
Жыл бұрын
QUESTION? What type steel
@jones_trees_and_treen
Жыл бұрын
These were an alloy similar to 5160. I have also used O1.
Пікірлер: 22