This guy is brave. Must never make any mistake. Congratulations
@christaylor5924
11 ай бұрын
Thanks for taking the time to make the video mate. Much appreciated and very helpful.
@47Edge
3 жыл бұрын
Nice job! Just pop the nose fairing and buy yourself some 6-inch hex keys with a 3/8 socket on the end and you can get to the top clamps through the gap in the plastics. Hope this helps!
@khuramnasir4461
4 жыл бұрын
Good step by step guide - well done dude!
@massimilianosciarrini2320
3 жыл бұрын
Great job! Thank you for this guide
@cstav7217
2 жыл бұрын
Great video and very helpful. Overhauling my forks right now. Replacing all seals and bushes. To avoid removing the tank again I am planning to re-route the fork cable (left fork) not to go under the tank - just hope is long enough. Just note there is washer that fits under the spring. You can see it in the spare parts catalogue and I thought I lost it but it gets stuck at the bottom - can be seen using a torch and fished out with a magnet. I think yours got stuck at the bottom as well. Great video, well done !!👍👏
@lakesbiker7286
3 жыл бұрын
Thank you great video 👍🏍💨
@michelledeluisa6200
3 жыл бұрын
I think you misplaced the orientation of the large black plastic part that goes on the right shock , minute 24:35, great video by the way.
@demo4342
3 жыл бұрын
The preload tube. I saw that.
@zoUpne
3 жыл бұрын
Yes indeed we did misplaced that part. I opened again and did it in the right direction. Thanks a lot Michelle.
@YarraMates
10 ай бұрын
This is mental amount of work just to service the forks. I just dropped off my MS at a local bike shop to replace the seals, but after seeing this i wonder if i should go to the dealer instead.
@kuhndj67
3 жыл бұрын
You can do it without removing the fairings and tank cover... I watched my service tech do it but you may need to modify some tools to get them to fit.
@michaelmcguire2778
Жыл бұрын
Don't take full top off once opened, crack bottom nut with 8mm Allen key and full insides slide out. Much easier. Putting seal back on, you risk damaging it sliding over the grooves, cover them with polypocket or glove to get seal over them.
@weetabix5973
Жыл бұрын
Thanks for posting this video. I have the right fork pulled apart and your video was very helpful. I backed off the preload and found that it was only a 3/4 turn (On the right fork). Just wondering if that is what you had? Just doesn't seem like much. I still have to change the oil and then do the left fork. Hopefully it goes ok. Thanks again.
@Gandalf
4 жыл бұрын
thanks crack!
@francescomanocchio5167
2 жыл бұрын
Nice job mate! Which and where did you by the workshop manual? Thanks
@kotvandal
3 жыл бұрын
after the bulkhead, the fork works only when the ignition is on, so should it be?
@StoleNo1
2 жыл бұрын
Hey man…Nice Video… I have same bike and want to change oil in forks. Can i do that only with unscrewing top cover from forks like you do it in 6:48? Thx 🙏✌️🙂
@Mihail_Korovkin
2 ай бұрын
Hi!!! No instructions. How much oil to pour into one fork blade? Thank you.
@chrisusmcvet3435
3 жыл бұрын
That is a royal PITA..... just to replace the fork oil.... it would be nice if there was a drain bolt/ plug and the bottom of the shock and a fill port at the top to use between bushing/ seal replacement service intervals.
@danblough5895
Жыл бұрын
Do you have to bleed air out of the forks?
@capaankit
2 жыл бұрын
Very useful video, which fork seals did you use?
@zoUpne
2 жыл бұрын
The OEM ones. I ordered them from local Ducati official store.
@junnimama
4 жыл бұрын
Nice... how did you remove the gas tank connectors ?
@zoUpne
4 жыл бұрын
What do u mean? The fuel connectors are easy. And the breath pipes have a second connection, u don't need to remove them from under the tank.
@nrvsauto8990
2 жыл бұрын
Good job! Where did you get your service manual from
@zoUpne
2 жыл бұрын
Go online ducatiforum.co.uk
@dumberfeet
3 жыл бұрын
thanks for the video, can you share the link for the service manual? going through this myself right now.
@zoUpne
3 жыл бұрын
Hi. You can find it at ducatiforum.co.uk at multistrada section ..
@SuperCheesyMan
4 жыл бұрын
great video ! where did you get your decals btw ? i have the same in white :) thanks
@zoUpne
4 жыл бұрын
Hi, thanks. Decals are made by me. Custom made.
@SuperCheesyMan
4 жыл бұрын
@@zoUpne ha that's why ! Really good job man :D
@mikael5677
4 жыл бұрын
Why did you do this service? My forks feel stuck after winter but i'm a new owner
@zoUpne
4 жыл бұрын
Forks need service after 30k klm .. i decided to do it my self just from curiosity and cause i care for my bike more than any service center.
@user-kw8nz5op3z
Жыл бұрын
¿que numero de dado es el grande?
@ketamyna
Жыл бұрын
Where do you disconnect the cables attached on the top of the forks?
@zoUpne
Жыл бұрын
There is a plug and play connection under the tank if i remember well.
@fredericcorsini7081
3 жыл бұрын
Thank to france
@restoration_and_repair
3 жыл бұрын
What oil did you used?
@zoUpne
3 жыл бұрын
Fuchs 7.5
@diegomarin5501
4 жыл бұрын
Very good step by step ; I get the question; how I get the manual ; my bike is multistrada 1200 s 2017 . Do you have e-mail.?
@zoUpne
4 жыл бұрын
Hello and thank you. Search for ducatiforum.co.uk .. you will find there everything you need.
@bulloncino100
2 ай бұрын
il distanziale nero è montato nel modo errato
@nikaia19
2 жыл бұрын
Καλησπέρα φίλε και εγώ από Ελλάδα είμαι!εχεις Facebook η κάποιο email γιατί θέλω να σε ρωτήσω και για αναρτήσεις και για φιλτροκουτι;
Пікірлер: 48