Hope that leak resolve itself Had similar on a brake system I’m working on where I I found issues from the previous mechanic It’s painful pulling it all apart again Fingers crossed for you!
@KCKLubricants
4 ай бұрын
Thanks! It's going to hurt the motivation if we start taking steps backwards 😪
@stefantrnacek1394
4 ай бұрын
One of my favourite jobs when building racecars is doing all the hoses. Anything from #3 to #20. Could you put a reinforced C notch in the accelerator pedal for a bit of clearance for the bias cable?
@KCKLubricants
4 ай бұрын
I agree, the hoses make everything! For some reason all of the pedal assemblies seem to be the same, when we build them from scratch we run it on the clutch side as it seems a smarter solution. There is just enough clearance until the brake pedal goes to the floor! The accelerator pedal has been shaped around the bias cable with a very large C in it, any more would almost foul on the drivers foot.
Пікірлер: 4