In this video, I break down step-by-step how to relocate your battery to the rear of your truck. This is a must when going aftermarket inner fenders. I used the GMSS Fab battery relocation bracket with some other stuff I snagged from Amazon. All the links are listed below!
Check out www.simplec10.co for parts, merch, and DIY tutorials!
Parts mentioned in the video:
GMSS Fab Battery Bracket: www.gowenmount...
0/1 Gauge Wire: ebay.us/sVxBeD
Battery Terminals: ebay.us/bojwa5
Ring Terminals: ebay.us/Ho4KsH
4 Post Power Block: amzn.to/416uuDl
Split Braided Loom: amzn.to/416uZxd
→ Become a Simple.C10 Subscriber!
→ Website: www.simplec10.co
→ Instagram: / simple.c10
→ Facebook: / simplec10
→ My Channel Home Page: @SIMPLE.C10
→ As an Amazon Associate, I earn from qualifying purchases.
If the video was helpful, remember to give it a "thumbs up" and consider subscribing.
Негізгі бет FRANCIS EP.12 | DIY Battery Relocation | GMSS Fab Bracket and Step-by-Step Installation Guide.
No video
Пікірлер: 32