I like the lock & load bushings that Hornady uses and they are the same for all if their presses. I do like the roller bearings for the ram, looked really smooth.
@brent26
8 ай бұрын
Thank you for the exact comparison I was looking for! I do think you could have done this perfectly in half the time however :)
@reloading1776
8 ай бұрын
Glad I could help!! SO???? Which press are you going with?
@peteseed5383
Ай бұрын
The Hornady lock'n'load bushings fit for easy caliber changes.
@reloading1776
Ай бұрын
been wanting to check them out.
@davecollins6113
4 ай бұрын
The M press does have some design flaws that didn't have to be there, such as the shell holder hold down plate and screws. Don't stick a case and try to use the press to pull it out of the die, it isn't built to handle it, and you can wind up with broken screws to deal with, and a bent plate. Johnny's Reloading Bench put the M press thru it paces and found a few other bugs as well. Not sure if the bearings on the F1 are a good idea or not, only time will tell on those. For the price, it'll compete with the Lee stuff, longevity will take a while to find out about.
@rickroper7880
10 ай бұрын
roll some with the 06 im curious. nice video Bro
@reloading1776
10 ай бұрын
Thanks
@fabienheussler5313
6 ай бұрын
Hi, thanks for your videos. You think it's possible to adapt the LEE breech lock bushing (tool Quick change) on the F1 ?
@reloading1776
6 ай бұрын
Give me a bit Ill try to find out.
@fabienheussler5313
6 ай бұрын
@@reloading1776 nice 😁 great thanks 👍🏻
@fabienheussler5313
6 ай бұрын
@@reloading1776 or maybe hornady lock n load conversion bushing
Пікірлер: 13