This is the premiere episode of a new modeling series, focused on questions and curiosities I've received from viewers to my channel in recent years. This is all for you, so share your suggestions and thoughts. I'll run with the questions about free-flight rubber-power that feel most universal.
The first episode focuses on the making of rubber motors that are 1, 2 or 3 loops, along with the braiding of each motor. The film also shows the making of the tool needed for installing motors, called a stuffer stick, and the use of a 'wobble peg' in the rear to help reduce the bunching of the motor.
*** 10 steps to trimming a rubber model, by John Koptonak: www.flyingacesc...
Here's a source for rubber: www.faimodelsu...
Generic rubber turns calculator: hallmanstudio.c...
Badge Classic DT & spring (at the bottom of the page): www.starlink-fl...
Here's a source from crocket hooks. www.faimodelsu...
37" Junkers J-1 based on the 30.5" plan by John Houck: hallmanstudio.c...
Also, these tutorials from Easy Built Models: easybuiltmodel...
***Interview with Tom Hallman by John McAvoy on his Free Flight Fanatic podcast:
freeflightfana...
Flying Aces Club merchandise: www.cafepress....
Center of Gravity merchandise: www.cafepress....
For more info on free-flight rubber-powered models & supplies, check these websites:
www.easybuiltmo...
volare-product...
www.flyingacesc...
outerzone.co.u...
National Free Flight Society - freeflight.org/
Mike Stuart's Flying Scale Models - www.ffscale.co.uk/
www.freeflight...
Негізгі бет Free Flight Basics #1 - Series Premiere - Braiding Rubber Motors
No video
Пікірлер: 307