I'm living your same exact nightmare on my 1988 FLA
@MrTrapichero
2 жыл бұрын
II had one just like it and the problem that the cabin did not go up was one of the hydraulic. I had the o ring broken. I replaced it and the problem went away.
@incrediblemember1208
2 жыл бұрын
Which O Ring did you replace???
@MrTrapichero
2 жыл бұрын
@@incrediblemember1208 I replaced the entire unit, that was in 1996. I bought it at the Freightliner dealer.
@incrediblemember1208
2 жыл бұрын
@@MrTrapichero By unit you mean the pump itself ?
@MrTrapichero
2 жыл бұрын
@@incrediblemember1208 I took it to my mechanic and he tested the pump and the hydraulic (they are the ones that push the cabin up) , the pump was fine,but one of the hydraulic did not retain pressure and that one was changed. I was not present when he did the tests.
@neilmcintosh1200
2 жыл бұрын
If the other gears select OK, then the rod isn't likely to be the problem. Look for wear and lost motion at the bottom of the lever in the cab or within the parts in the casing at the other end.
@cruisingtheroad3903
2 жыл бұрын
Also you can adjust the length, where the shift linkage meets the u joint at the shift remote. Just make sure the u joint has enough material to bite on the shift linkage.
@the7tongardengnome
2 жыл бұрын
Same thing happened when I changed my cab height. It put the gear shifter out and I either couldn't get 3rd gear and reverse. So I had to mess around with it for ages.
@kranz19
Жыл бұрын
My rubber boot at the end leaks oil is there supposed to be an o ring to prevent that?
@incrediblemember1208
Жыл бұрын
Links on the shifter? Those have greese in them, replace boot or keep her lubed up
@garymodesitt9536
Жыл бұрын
Get a hold of tim Gentry and sons trucking you'll find on KZitem you could
@MrTrapichero
2 жыл бұрын
Check with Truck and Parts, Tampa, Fl.
@guillymendoza6514
2 жыл бұрын
Heyi got the truck now I need to get In touch with u
@incrediblemember1208
2 жыл бұрын
How can I help you?
@guillymendoza6514
11 ай бұрын
Why is it blowing white smoke on idle bro
@cruisingtheroad3903
2 жыл бұрын
You might be better off converting it cable shift, if you have some fabrication skills. K100 and argosy are cable shift. Keep at it, 1 at a time and youll get there👍
@the7tongardengnome
2 жыл бұрын
Yeah buddy its daylight robbery. Almost criminal what you pay for truck parts.
@jamescullum8667
8 ай бұрын
That’s the wrong remote for that setup
@tossedsalad5532
2 жыл бұрын
Have you searched a wrecker in Mexico or Canada for the shifter Part?
@incrediblemember1208
2 жыл бұрын
No I havent looked
@tossedsalad5532
2 жыл бұрын
@@incrediblemember1208 what part do you need ? What model is the truck and year again
@incrediblemember1208
2 жыл бұрын
@@tossedsalad5532 I need the last linkage that connects to the trans , 1994 freaghtliner FLA/FLB share the same parts
@tossedsalad5532
2 жыл бұрын
@@incrediblemember1208 what's the length of that shaft ? Was just told there are 4 options of length. They need to know the length
@incrediblemember1208
2 жыл бұрын
@@tossedsalad5532 Someone cut the end of my linkage, but I will use a tape measure and see how long it should be to the shifter when I get home next week , Thank you for trying to help!! it means alot to me !!!!
@MjK931
2 жыл бұрын
do research before you cut anything
@incrediblemember1208
2 жыл бұрын
Someone already cut the tail off I need to extend it! to how it was
Пікірлер: 29