Love all your videos. I watched the Baron H install about three times. It really helped me during my own install.
@christopherdekonstrukt444
Ай бұрын
Apparently the socket is proprietary as there are no drop-in replacement LED bulbs that have a staggered 3 pin design.
@yorikvatral929
5 жыл бұрын
Thanks Sir, light looks great !👍
@ethanmaheng1295
5 жыл бұрын
Exactly what I needed!!
@Jrockin629
9 жыл бұрын
Really liking the videos! Quality!
@3613jeremy
3 жыл бұрын
I'm trying to convert my Yamaha Raider from the stock 3 wire bulb to some smaller LED bullets. But for the life of me I can't figure out why the running lights won't work checked everything with a 12v battery before installing them but once I connect the 3 LED wires to the 3 bike wires all I get is the turn signals I hate messing with electrical systems
@jasonbell3536
2 жыл бұрын
Hey for the what size socket wrench did you used for taking off the original front flashers? I’m trying to replace mine but can’t seem to figure out the right sizing
@YoDooDSup
Жыл бұрын
This is what I do. I take a handful of open ended mm wrench’s and try them all. Example, if I have a 9,10,12 and 13. The 10 is JUST too small and the 12 is JUST too big. It’s an 11. Some would call this trial and error.
@bengoodman6112
4 жыл бұрын
It's the AIT sensor that has to be unscrewed from the oem signal.
@damienpalianta6325
3 жыл бұрын
What is that? I'm replacing mine on my bike and was wondering what it did
@bengoodman6112
3 жыл бұрын
@@damienpalianta6325 it reads your air temp and adjusts your air/fuel mixture.
@damienpalianta6325
3 жыл бұрын
@@bengoodman6112 oh IAT then, had a panic attack googling thinking i done forgot something important lol
@nicklugo7068
3 жыл бұрын
Just a Curiosity will the wiring work for a Yamaha Stryker with the LED fork lights?
@jrsandiego
3 жыл бұрын
I am not familiar with the Stryker so I can’t say if the wiring is the same..
Пікірлер: 14