If you enjoyed the video, please give it a *thumbs up* 👍 Your support is *greatly appreciated* . Also check out my *STEREO Upgrade* : kzitem.info/news/bejne/q3ikuJyAg4B_dHo *REAR SPEAKER Upgrade* : kzitem.info/news/bejne/0IJr4I5-aWuHqHY and *FRONT SPEAKER Upgrade* : kzitem.info/news/bejne/unyauJmLo3WWqGU
@imBUZZed_VWoC
25 күн бұрын
Amazing videos. Great job! I’ll be doing all speakers on my girlfriends 2015 Carolla while she is out of town for a few days.
@CleverFix
22 күн бұрын
Wow, That's a nice surprise for her!
@giovannifraioli2428
9 ай бұрын
EXCELENTE VIDEO, INSTALE ESTOS TWEETERS EN MI COROLLA 2016 Y EL CAMBIO FUE DEL CIELO A LA TIERRA, GRACIAS, LUCEN COMO SI FUERAN DE FABRICA.
@iTzDaNiiLo
Жыл бұрын
I was looking for a video on this like a week ago and you came out with this video. Clutch! Thanks for posting
@joewhattoff8754
Жыл бұрын
Canada man, they sound pretty sweet. The voice and instruments really pop
@CleverFix
Жыл бұрын
Yes they sound great.. It took a few days to adjust, at first I thought there are too many highs, and I turned them down.. but eventually I turned the highs back to normal and it sounds great. I guess I was used to flat music without highs.
@omarandres4665
5 ай бұрын
@@CleverFixHow do you adjust the highs?
@drosos-vr9fl
Жыл бұрын
Thanks a lot for your infos ! I made the project i am very excited.
@CleverFix
Жыл бұрын
That's Great!
@mrchad97z49
4 ай бұрын
never solder speaker wire. Solder adds a lot of attenuation and the heat does the same. The neat result is more attenuation is less sound.
@CleverFix
4 ай бұрын
Pre-twist and solder properly, and you'll get a good connection. Solder is used everywhere. Even the factory solders from the spade terminal the coil of the speaker, and in the car stereo the pins for the speaker wires are soldered to the circuit board. pasteboard.co/MK5GQgVCE42Z.png
@LAZER1LAZER
10 ай бұрын
Will there still be a sound quality increase without an amplifier? I'm assuming these are low impedance speakers if you're using the stock radio
@JosephMustafa-kx6hg
6 ай бұрын
The answer is yes with high sensitivity speakers - like every Infiniti reference speaker they win be louder and cleaerer even on stock
@adamthewoodworker2571
9 ай бұрын
Thanks for your detailed responses. One last question, do you have a video where you demonstrate the best way to do/best place to put the grounding wire for an amp on a 2014 toyota corolla
@armandoramos1949
9 ай бұрын
Thanks for sharing, made that looks so easy.
@CleverFix
8 ай бұрын
You’re welcome 😊
@scottwatrous
11 ай бұрын
If I dont have a solder gun handy any reason not to use butt connectors here as done with the 6" speakers?
@CleverFix
11 ай бұрын
You could use butt connectors yes. I prefer soldering when possible, that way if there's an issue I know for sure the soldered connection is not causing it. On the speakers I had no choice, because it's aluminum to copper, so it can't be soldered. Make sure to squeeze the connector really well.
@khalilJon
Жыл бұрын
Hi clever fix, I have base model Corolla didn’t came with tweeter can I buy them tweeter and plug and play
@greenlife1041
Жыл бұрын
Excellent job 👏
@CleverFix
Жыл бұрын
Thank you 😀
@edgarcamacho5580
5 ай бұрын
Como los puedo conectar si no tengo adaptador?
@Lemiak
Жыл бұрын
Excelente!!! Bravo!!! superrr
@stanl2249
11 ай бұрын
Sir,which tweeter speaker best install with sony car tape
@00M1
Жыл бұрын
Do you think there is a way to keep it looking OEM? (After the upgrade)
@CleverFix
Жыл бұрын
Paint the mount with flat or semi-gloss black paint before installing it if you don't like the white writing. There's no other way, installing the tweeter without it's mount will not sound good (double grill is bad for sound).
@joeponder9668
Жыл бұрын
My dog, enjoying the video so far, are you from Hungary? You sound identical to my buddy who lives there. I am doing this same thing for some skar tweets.
@CleverFix
Жыл бұрын
Nice! Skar tweeters are great.. I was going to get some, but it was harder to obtain them than the Rockford, and I figure the quality will be very similar.. The Skar may be louder.
@adamthewoodworker2571
9 ай бұрын
Do you know if they sell the mount part by itself?
@CleverFix
9 ай бұрын
They're sold together,.. Most brands will come with their own flush mount. Check the included items in the manual for the tweeters you're considering, and it should show what's inside as well as the cut-out template, with the width for the hole required so they fit in perfectly. Here's the R1T-S: rockfordfosgate.com/rftech/library/2012/4_speakers/rf_primer1speakers_cutout-irs.pdf it's 1.83" , top right of page 4.
@nancycusano3331
6 ай бұрын
Tweeter is to big for mount
@mariw436
Жыл бұрын
What about capacitors? OEM tweeters have them built in
@CleverFix
Жыл бұрын
Yes the Rockford Fosgates have them built in also, they're at the back, I show them in my Unboxing video kzitem.info/news/bejne/z25ttYKrr3t5d5g
@snaketripp
Жыл бұрын
is it required to dremel into the plastic? in other words can the new tweeters fit into the OEM housing ?
@CleverFix
Жыл бұрын
They fit, but the tweeters have their own grill. They are not designed to be placed behind another grill, and will sound quite bad. I would rather not do the upgrade than place them behind the grill, that's how bad they sounded to me.
@sulentickresimir9963
9 ай бұрын
PERFECT
@toddpainter8615
Жыл бұрын
Why wouldn’t you just mount the new speaker in from the back?
@CleverFix
Жыл бұрын
Double grill for tweeters makes them sound horrible. The grill it comes with is optimized for the tweeter to sound good. Any other grill or obstruction of the sound will reflect the sound and it sounds bad, I tried.
@rezaghahreman86
Жыл бұрын
Thank you for this video. I got a question about Bluetooth that is not related to this video. I have issue with my Toyota Corolla Bluetooth. When I get a phone call over Bluetooth, it is very noisy. The other side of the call cannot hear me. Do you know how I can fix it? Thank you!
@CleverFix
Жыл бұрын
Did you try another phone? You have to first find the problem to fix it. If it's bad with every phone, then it's the car at fault. Try another phone first. The microphone is in the dome lights right above you.. so if there's something wrong with the microphone, it could be replaced. Lastly if there's something wrong the stereo, you can try another stereo from a junk yard. I will be posting a video on how to upgrade the stereo with a Pioneer within a month or so.
@Pinkielover
9 ай бұрын
remove the letters then it would be perfect
@CleverFix
8 ай бұрын
Spray paint with a Matte/flat color is probably the best.. 3-4 light coats, and it can cover it nicely.
Пікірлер: 44