Very good video. Need more like this for the up and coming techs. Fryers can be tricky, tilt pots is another one that gets me every so often
@justanoldhandyman
3 ай бұрын
Enjoyed the video, Thanks for sharing.👍
@markcampbell4576
3 ай бұрын
Brings me back tp some good old days, replaced plenty of crack burners on them things, 💥 boom 💥 🤣🤣
@al6347
3 ай бұрын
The old hit the gas value with the screwdriver. Scientific observation. 😂😂😂
@restaurantrepairs
3 ай бұрын
When I was training my helper he was at a no heat call and I told him to whack the valve on a carrier and it fired off. He was like WHAT!?!
@aleksandarvasilevski7410
3 ай бұрын
I work mainly in heating with large burners. Combustion analyzer is a must when adjusting gas burner. You need simplest device that can measure oxygen content in order to adjust combustion and secure lit each time. Yes, probably it is relay but adjusting air according flame color can distract you from the real problem.
@restaurantrepairs
3 ай бұрын
Great point 👍🏼
@inothome
3 ай бұрын
I was going to ask if there was any PID loop in that controller, tech support answered that and it does. I did notice when it shuts itself off the heating light on touch panel goes out. But when you pulled the relay off the board when heating the light stayed on on the touch panel. So like you eventually figured out, nothing wrong. Operating as designed.
@chompnormski
13 күн бұрын
The anticipation circuit built into the computer makes the heat cycle ramp up to setpoint. If it were to shut off the heat cycle at setpoint, the temp would over shoot. He has to be in a jack in the box 😂😂😂
@berylwhite2983
3 ай бұрын
You're doing a great job! But I hope your wife and kids are not watching these videos because they're going to learn to swap your parts while you're asleep and then all the sudden you'll be tired when you get up and you won't be able to sleep all night. But I imagine they'll be good to you you seem to be a good person so I bet you've treated them all extremely well! So you have a wonderful wonderful day. And you are an extremely good technician.
@billbennett5437
3 ай бұрын
Yup, I changed 3 of them in the past week.
@jrh86
3 ай бұрын
Pain of a fryer 😆 hate them.
@al6347
3 ай бұрын
Frymaster is a bad word.
@InsanePickle24
3 ай бұрын
I work at Burger King and we had this exact same problem with one of our fryers before.
@jw9396
3 ай бұрын
my moneys on relay😬
@harrydickson4575
3 ай бұрын
Whatever happened to the simple millivolt fryers lol
@hvacrnortheastern2110
3 ай бұрын
l was going to say the same-thing.I haven’t work on one in about 20 years they over engineering equipment. nowadays
@mattparker8304
3 ай бұрын
Frymaster strikes again
@OcRefrig
3 ай бұрын
Good video ! Relays Burnt. You need a New Relay anyway u look at it. order & install a New Relay min. How old are those fryers ?
Пікірлер: 20