I have nissan naavara d40, my problem is that after traveling for almost 40k my truck begins to lost power and emit black. I have cleaned fuel tank, change fuel filters but still the problem exist..thanks for any advice...
@jnep9756
4 жыл бұрын
Hi, near the SCV is a wire connection , what sensor is there , i have the connection but is not connected to anything
@rodneykufa352
3 жыл бұрын
we a nissan np300 2.5. the vehicle has no power but if you switch off and on whilst the vehicle is in motion it will perform back to normal but the moment you brake the vehicle will loose power again. the diagnosis came and said the pump needs attention.
@melvinbasson4780
3 жыл бұрын
Did you manage to solve the problem
@hassangooner233
14 күн бұрын
Did you solve it, also mine does the same
@johnlett3715
12 күн бұрын
Replace sensor on gearbox
@mpapadimonyela7508
4 ай бұрын
Thank you. I was ready to throw away my car
@josephnganga804
2 жыл бұрын
My np300 yd25 engine will get a little bit stuck on rev 900-1100 and rev slow and after that it will do perfectly... When driving when going over a bump and the rev goes below 1 especially on gear 2&3 it will rattle also when when loaded on a small hill it will rev down and will turn off forcing me to use 4wheel drive high what could be the cause and how can I resolve it? Thank
@EvenFlow12345
5 ай бұрын
Did you figure out the issue?
@markthompson1134
3 жыл бұрын
my nissian x trail is not starting its coming up low rail pressure could this be the problem
@bignig2278
Жыл бұрын
Why not show where the suction control valve is on the motor
@mariamasalim9925
4 жыл бұрын
876 peugeot 206
@SCMode
3 жыл бұрын
hello, i replaced fuel flow control valve, remove fault with computer, but after test drive same fault occurred and same things happening, no power etc, where to check whats wrong?
@modrix
3 жыл бұрын
EGR valve?
@lukepaki7231
3 жыл бұрын
Trade it for isuzu
@TheDesperato
3 жыл бұрын
The sensor.
@emmanuelthill6452
Жыл бұрын
@@TheDesperato which sensor?
@shabibajwa9816
3 жыл бұрын
Hi guys, I have Navara d40,2010, we replace clutch and after that rev not go above the 3000. Attached the scan tool it’s shows code PO335, crankshaft position sensor ,any idea to solve this issue, please advise me. Thanks
@thelonewolf2181
2 жыл бұрын
There's is sensor on the gearbox just need to replaced it.
@shabibajwa9816
2 жыл бұрын
@@thelonewolf2181 , you are the great. Changed the sensor and problem solved.🙏🙏
@promisemussa2355
4 жыл бұрын
i have my nissan navara yd25 d40 it only cranking but not starting ,but if you do hard push it starts well.i took injectors for service and clean fuel tank but the problem still remains the same what might be the problem
@Emmanuelteina
Ай бұрын
Check your glow plug relay. Try direct heat and crank it
@mompatimase167
5 жыл бұрын
Hey buddy. Where can i find that EGR cooler.
@modrix
5 жыл бұрын
Actually hard to say because I already forgot about this car so I can tell you perfectly I hope you will try and Google maybe find some picture thank you very much
@mompatimase167
5 жыл бұрын
@@modrix I know what the cooler is.. mine has a hole in the heat exchanger and I just can't find one to buy, at a sensible price atleast. Nissan wants crazy money for it out here in Botswana ($1,400).
@modrix
5 жыл бұрын
@@mompatimase167 yes I believe you once I try to buy in Nissan dealer cabin Fan motor and they said to me 500 euros but I both in China AliExpress for just 80 Euros
@mompatimase167
5 жыл бұрын
@@modrix thanks very much I'll look it up on Aliexpress..
@ephraimnjoroge6157
5 жыл бұрын
@@modrix my care rev reach only 2000rev per min. Dpf had an error p2002 n i cleared that what else can i do pls. When i depress accelerator the rev read 2000 rev per min. Pls help. Somalia no engineers for nissan car. Am lucky i have little abt them
@armandosejdiu917
2 жыл бұрын
Can i ask why my nissan navara sometimes dosnt go up to 3 abortail what is the prob i put a new injectors i changed the old one and again i have problem with power aometimwa goes good sometimes stops please help me
@mphoramokolo5555
2 жыл бұрын
It is most of the time ur scv.
@KR7PT
4 жыл бұрын
Only a matter of time before that Navaras timing chain snaps, why bother 😂
@Mr330d
3 жыл бұрын
In fairness the chassis could snap in half before the timing chain
@SalimKhan-gk1fh
3 жыл бұрын
@@Mr330d I’m not sure what is worse, the chocolate engine Or rusting chassis’s ? And now mercedes use that shit!
@Mr330d
3 жыл бұрын
@@SalimKhan-gk1fh Mercedes x class premium price for rubbish quality 😂 it’s like buying an A180d with Renault 1.5 Dci engine 🤮
@SalimKhan-gk1fh
3 жыл бұрын
@@Mr330d yes u are dead right, do u watch salvage rebuilds uk? When they stripped the Mercedes GLA I was shocked that it was Renault rubbish! I will stick to my Audi allroad loved them last 15 years!
@natiqibrahimov1766
5 жыл бұрын
Hello. I don't have a car speed. How can this be?
@user-qm5uh2vv5s
4 жыл бұрын
abs problem
@octaviantrutulescu3931
3 жыл бұрын
hello i have an pathfinder 2006 also without DPF, i have no error on the tester but it does not make pressure on the intake, it has a very low vaccum pressure in the pipe that enters the selenoid sensor, i verified the pipes, there are ok, can you tell me what should i check next ? Thank you !
@modrix
3 жыл бұрын
Vakum pump
@petermatovolwa6446
3 жыл бұрын
You're explaining to tech people. Try to explain to users
@TollyTolly
4 жыл бұрын
I can see a lot of different car with denso fuel system, have same problem Company's should refuse using their systems, they are crap
@HaysieBoy
4 жыл бұрын
My 2009 Navara goes into limp mode when I set off quickly. It shows high pressure system fault code. Other than that there is very little power at low revs until 2500. Hill starts are nearly impossible. Once over 2500 revs it flys along no problem. Could this be a valve issue too??
@modrix
4 жыл бұрын
Yes
@mohamedkhan1270
4 жыл бұрын
Suction control valve by diesel pump, expensive but sorts the limp mode issue out
Пікірлер: 66