So, this is super helpful. Unfortunately for me, I only saw this after I did the battery swap myself. When I pulled out the old battery, I inadvertently ripped the ribbon cable going from the BSM to the connector. Is is possible to reconnect these two pieces?
@smartazz
4 ай бұрын
Yea it is possible to reconnect but it will probably take more time and cost too much to repair economically and safely.
@Her0Speedy
6 ай бұрын
What is the thing that you used as other battery? to power the iphone when the original battery was out?
@smartazz
6 ай бұрын
The board powers the phone with the connecting cable when the battery is connected with the board. My other battery is the spot welder battery.
@Lyngvegen10b
3 ай бұрын
How get this board ?
@Lyngvegen10b
3 ай бұрын
@@smartazzhow by this board
@smartazz
3 ай бұрын
@@Lyngvegen10b will only work if iOS is 17.3 or less 17.4.1 will not reset the health. They are on AliExpress
@felixtellegen7258
3 ай бұрын
@@smartazz You still can. If you do the same repair as you did in this video and later on do a flash with 3utools to 17.4 and pressing "restore battery health"
@Lyngvegen10b
3 ай бұрын
After 17.5 ? Dont change to 100% ?
@smartazz
3 ай бұрын
Correct
@smartazz
3 ай бұрын
If you replace battery and keep original BMS it might say recalibrate health in settings if your lucky.
@ASTROEFEKTY
4 ай бұрын
what about restoring/reseting phone?
@smartazz
4 ай бұрын
If done before iOS 17.4.1 then your battery health will stay reset.
Пікірлер: 26