How to progam the onboard analogue input on a mitsubishi FX5U PLC ontroller. Also i show you how to parameter the built in scaling function.
@vladimirkarcol9008
10 ай бұрын
Hi, how to convert to real temperature with PT100 and AL2-2TC-ADP converter so that it also shows minus temperatures? The converter gives signals 0-10V 0-4000. is the value thank you very much
@zellerautomationandplc
10 ай бұрын
Hello, i do not work with alpha controller too much. In order to help you with that i would need some time.
@user-nm7xd6gx8s
6 ай бұрын
hi ive got a pressure trandsucer -1 bar to 12 bar 0-10v signal how do i get it read accurately
@zellerautomationandplc
6 ай бұрын
Hello, thank you for your question. Please view my video at 1:55mins. Also calculate 12 Bars with a resolution of 4000 Units you will end up with an accuracy of 0.003 Bars. If you now set the "Scaling upper Limit value" to 1200, you will have a resolution of 0,01 Bar. If you set it to 120 the resolution will be 0,1 Bar. I hope this answers your question. Regards Gerd
@user-nm7xd6gx8s
6 ай бұрын
thanks for the response i have a q series plc so how can i enter the information i dont have the module parameter: analog input section@@zellerautomationandplc
@zellerautomationandplc
6 ай бұрын
Hello, i have a Function block for FX CPU`s where i can make these calculations. Unfortunatley not in Q Series. If i send you a printout of the program can you write it in Q-series?
Пікірлер: 9