Yet another GREAT build Sam. Really enjoy your video's. I learn more every time and I've been building boats for over 30 years. Never too old to stop learning.😁 . Thanks for putting in the time to do all that editing etc.
@jaymeparker27
Жыл бұрын
Motor cowling looks great!
@chilly7261
Жыл бұрын
Thank you
@darryldeel9098
Жыл бұрын
Next several days will be good building days
@chilly7261
Жыл бұрын
And therein lies the problem... 😥
@georgegonzalez9281
Жыл бұрын
What brand of outboard are you using? It looks like a scale outboard with a gear drive, or is it a flex shaft? Will it handle 4s? I'm surprised you didn't use a long tail outboard like a Lawless clone or O.S. clone which has a lot of adjustability and can handle lots of power. Just curios. Very nice custom cowl by the way!
@chilly7261
Жыл бұрын
Thank you. It's a Scale Seven outboard from OSE. Gears and bearings in the lower end. Going to run the motor recommended for this hull on 4s. A 3660, 2050kv. I built the cowling to fit that motor. I really wanted the scale look...
@toddshobbyzone659
11 ай бұрын
What do yo seal the fuselage with?
@jacobscourtes576
Жыл бұрын
I'm having a tough time finding a flat build table for my g30 build
@chilly7261
Жыл бұрын
I was going to mention in an earlier video where I got mine, then I forgot to say it. Get a bifold closet door, unscrew one section, use that. The faces are luan plywood, soft enough to push in hold down pins. The inside is supported with zig-zag patterned corrugated cardboard on edge. It has wood edges glued in around the outside. I cut mine shorter, carved out enough cardboard to glue the one end edge back in. These are very flat and stable...
@jacobscourtes576
Жыл бұрын
@@chilly7261 thank you for the advice your is built to perfection mine probably won't be as perfect as yours but I really enjoy the building process
@chilly7261
Жыл бұрын
@@jacobscourtes576 Thanks
@jerryfarrell1218
Жыл бұрын
probably goes too fast
@jonathandemaria1865
Жыл бұрын
What is the manufacturer of the angle meter and where did you get yours
@chilly7261
Жыл бұрын
It's made by Align. You could find it at HeliDirect.com
Пікірлер: 16