This video follows the completion of the Battlestar Galactica launch tube. This is a 3D printed project and all of the files can be found at the links below on Thingiverse. Here you will see me assemble the completed tube along with the launch area and Viper. The diorama fits into a 15" display box found at hobby lobby. The video concludes with a review of the completed project.
UPDATE 4/20/21: The steps were reprinted and seam addressed. I know they're not accurate but it was the only way to fit them into this display. Thanks guys for all the great comments.
Links:
Lighting: evandesigns.co...
Launch Tube: www.thingivers...
Additional files by LJB: www.thingivers...
Viper: www.thingivers...
Plastic Mirror sheet: www.amazon.com...
Marc Fraley’s Files
www.thingivers...
Figures used for Apollo and Boomer:
www.thingivers...
Other figures (use pullover jeans backing off for mechanic, standing for Adama):
www.thingivers...
Display case:
www.hobbylobby...
Colors used:
Grays for the ports and walls: Country Gray from Apple Barrel; Added Ashen Blue from MSP for floor
Gray for launch ramp: Graphite from Craftsmart
Viper: Testors Light Gray, striping Vallejo Orange Red
Uniforms:
Jackets, boots, belts Vallejo Burnt Umber; Pants and shirt Vallejo Ivory, Khaki and Green Umber
Adama: Prussian Blue
Technicians: Vallejo Orange Red
Other Supplies from Evergreen scale models
6.3 X 9.3 tubing for SMD lights
6.3 X 6.3 Added rods increasing height of beams
Негізгі бет Galactica Launch Tube Completion
Пікірлер: 211