El flujo de ese ventilador es mucho menor que el original lo que provocará que los condensadores SMD se calienten mas y duren mucho menos. Yo optaría por una modificacion del molde de plastico y un ventilador de 50mm Delta de +5000rpm pero hará mas ruido que el original
@paulbrennan5807
2 жыл бұрын
i did the Noctua NF-A4x10 FLX upgrade but went back to the stock fan because the temperature went up loads so these little fans dont work well whats the point of it being quite if the thing bakes
@heatheasley751
3 жыл бұрын
Clever mod!
@legostarwarsrulez
Жыл бұрын
What made you decide to get this over the fractal design 50mm fan which in theory could also fit?
@Recuerdos2323
2 жыл бұрын
hi men nice work
@seanwilliams5848
3 жыл бұрын
A tip for next time if you are going to do stuff off camera then explain what you are doing or just keep your hands in view of the camera
@techclub8528
3 жыл бұрын
Yeh thus video is not the greatest I was thinking of redoing it. Problem is I work a long hours on my day job so KZitem for me is just a hobby
@SvenBudak
2 жыл бұрын
Where can i buy this power cable?
@pittstone
Жыл бұрын
i saw this on many Fan Mods. Why is the Fan in Wrong Position? The Fan should blow fresh Air into the Console, right? And the Heat should blow on the other side out. But every Fan i see in Videos suck the Heat inside out. But the smaller Fan, like Noctua Mod with 40mm has not the power to suck the fresh Air from the other side of the Console, the long way from heatsink of the console to the fan and Blow it out. Its better to blow the fresh Air direct into the Console. I have now from 50 Celcius down to 45 Celcius after i changed that.
@legostarwarsrulez
Жыл бұрын
Nintendo from the factory designed the case to work in a negative pressure setup (fan sucks air out of case, instead of blowing air into it) and while spinning the fan around to make it a positive pressure setup probably wouldn’t hurt, why would you? The stock negative pressure setup works perfectly well.
Пікірлер: 10