Thanks for the video. Had the same problem with my 2005 TXT Pro 300. Clutch pack was over the 10mm and required the strength of a gorilla. Only problem was finding a suitable surface to sand the plates...wife's plate glass coffee table to the rescue. Clutch now a pleasure to operate.
@wilmersandelius8
6 жыл бұрын
Do you need to air the clutch after you've done this?
@ClumsyToast
Жыл бұрын
Hmmm, my discs are sitting at about 10.2mm as well on my 02 txt pro 280. I guess I'll try sanding them down; they just seem so thin as is! Can't hurt though. I figured I would have to replace them anyway. Rebuilding the master cylinder while I'm at it because it's just absolutely stupid hard to pull and doesn't really disengage it :/ Great video though! Serving people 9 years later haha. It's about the only thing I can find online about this issue.
@jotacalvo
8 жыл бұрын
Excellent video! Thanks. I had the same stiff clutch on my 2003 TXT Pro 280. After watching this video (and much research on Internet) I pulled my clutch and found virtually the same scenario. Now the clutch is buttery smooth, and only 1 finger to pull, as opposed to 2-3.
@guitaristLee
7 жыл бұрын
This worked well on my 2006 Txt Pro 300. Thanks for the vid.
@raffaelmeyer5243
8 жыл бұрын
the clutch is normal men on my 125 EC is the same when you pull the clutch... same feelin light fast... its normal...
@Mr09worthy
6 жыл бұрын
I have the same problem on my 2002 280 pro, would all the same apply to my bike?
@mikelyons7511
6 жыл бұрын
You didn't take them out correctly or in the order they came in on the side that they were touching each other. So your measurement is incorrect.
@pmay222
6 жыл бұрын
That lad has terrible kick clutch gear technique. . 😁
@mikelyons7511
6 жыл бұрын
Quit crying about it, and use your left hand in the shower next time
Пікірлер: 10